To Watch the NEXT Video: https://youtu.be/EElwI0fIR4o
To Watch the PREVIOUS Video: https://youtu.be/EC0l8UWmhUE
In this video I will be showing a quick over view of the damaged camshaft because of the faulty lifter. These engines come with collapsible lifters and they sometimes fail and damage the camshaft end or the camshaft bearings, which result in a load ticking noise. This is a slightly better video of how to fix this issue, a do it your self. This is a 2013 Dodge Hemi 5.7 LARAMIE. I believe it runs from 2010 Hemi 5.7, 2011, 2012, 2013, and up to 2014 Hemi. If you guys have any questions or need help, please comment down below! Thanks for watching I hope you guys support this new youtube channel that I am trying out. Comment of any new videos you guys would like to watch. P01416, P0300, P0301, P0302, P0303, P0304, P0305, P0306, P0307, P0308
I'm sorry about this video, having some audio issues and it was cut out 🙁
Did you have to replace camshaft bearings
Did you replaced the lifters with mds delete
Head bolts are not supposed to be lubed. Gives a false torque ready. But great video
You still reply bro ? I have a question
Hows it going bro how do i get in contact with you ? Im located in pomona inland empire and i see you work in the inland empire as well . Im trying to get this fixed asap . Have the same problem but no codes
I noticed the lifters were place 180 from each other as the bleed off holes were opposite. Does this matter or what not sure but thought I would ask. Great vid. Thank you
Please don’t reuse head bolts.
Dodge need they ass in court it’s millions of people have the same problem and people still buying the crappie trucks
You put cylinder head without planing? Will it not be a problem with the gasket in the future?
You just don’t explain sh it.
How can I tell if the bolts are stretched ?
With this type of failure did you get any type of code? I have a 06 300c ran fine and strong stop for gas went to start it just cranked but no start until you go half throttle then a rough idle with slight knock/rattle then stall.
Doesn't it happen all over again with those OEM parts? Why not upgrade the lifters and cam material?