How To Assemble and Install a Front Bumper – 2017 Subaru Outback

How To Assemble and Install a Front Bumper – 2017 Subaru Outback

How To Assemble and Install a Front Bumper on a 2017 Subaru Outback. 2015, 2016, 2017, 2018, 2019 Subaru Outback should all be the same. In this video we should how to assemble the front bumper: the grille, fog lights, and cover. Then, we show how to install it back onto the car, where the clips go, how the bumper fits back into place, and more.

If you feel confident in your car repair skills then add this to your DIY projects. In this video we cover the steps on how to install clips, bolts, covers, panels, and parts for the installation of the bumper cover.

#suabru
#cars
#diycarrepair

Got car questions for diycarhunters.com? Comment below and our team will try their best to answer. Need car parts? We buy our parts from ahparts.com, call them at (916) 859-0027.

5,714
Like
Save


Comments

Francois Painchaud says:

Thank you for this.
I have to resnap my bumper after it came out when i got stuck in a snowbank. Just have to wait till it's warmer outside so the plastic won't break, Might do a lense upgrade at the same time. The EOM lowbeam are not the best.

FENNBOT FPV says:

I have a legacy of the same year and the headlights and grill look the same it looks like the outback bumper will fit the legacy and I really want to try. What do you think? Would a front bumper cover from the outback fit on the legacy? Both are 2016

Granite Ridge Greens says:

What makes the louvers open and close on that upper grill? I had a rock go through the center drivers side of grill and now warning dash lights are on. Engine light, rough road light, warning icon and cruise control is not fuctioning but flashing on and off?

Fred Harvey says:

Nice tips on removal. I need to replace my windshield fluid sensor. It's dead.

George Bass says:

Do you have any info on Outbacks with parking assist sensors?

gwu aab says:

smart design by subaru – bumper assembly is completely separate from the headlights

swingmanic says:

Did you put the clips on the spotlights after fitting the bumper?..Secondly, I always drop the bonnet on my Subaru Outback rather than push it down as I think they are aluminium and dent pretty easy…Nice job though!!

Nadir Husain says:

Would you guys happen to have 2018 subaru outback rear bumper and tailgate with rear windshield?

Comments are disabled for this post.