I would us a longer bolt and come in from the opposite side …send it thru the same nut in the same position hold said nut with a whench and use impact after bolt has made contact with nuckle …i havent done this but it sounds like a better plan and the impact im sure makes it easier
){kind=link}
It helps but a pipe wrench and sledge hammer will get it done quick
Just bolt on the rotors backward loose and just yank it off
I would us a longer bolt and come in from the opposite side …send it thru the same nut in the same position hold said nut with a whench and use impact after bolt has made contact with nuckle …i havent done this but it sounds like a better plan and the impact im sure makes it easier
I just beat the hell out of it
Tried this, snapped the bolt because it’s so stuck on their….
If you’re not pushing the bolt through the stud opening why remove it just place the bolt against the of it
Thank you very much. You saved my life
yah do that with a rear ford explorer hub… good luck!
How did you cut off the stud?
I'm struggling how to open it
Maybe 5/8 bolts not 3/8 lol.I had to use heat and an 8 pound sledge