A quick video showing how to replace the brake pads and rotors in an MKX or Edge. This is the rotor – http://www.amazon.com/gp/product/B002L6L77Q/ref=as_li_t…
A quick video showing how to replace the brake pads and rotors in an MKX or Edge. This is the rotor – http://www.amazon.com/gp/product/B002L6L77Q/ref=as_li_t…
You must be logged in to post a comment.
){kind=link}
Is this meant for Edge’s with 16’ wheels?
Don’t the 17’+ wheels have that rubber plug on the rotor?
How do you go about getting those off?
No, when push the caliper pistons back to make room for the thicker pads (new), when you do this, you’re actually pushing brake fluid back into the master cylinder. When you first start the car, you’ll need to pump the brakes a few times to fill the lines back up before they feel right. You only need to bleed them when you remove a brake line or open a bleeder screw.
You didn’t have to bleed the brakes?
What type/brand of break pads/roters did u use in dimo?
I have heard that a small amount of brake pad lubricant on the clips, where the pads touch the caliper on the side opposite the pistons, and on the caliper slide bolts will further eliminate any possible noise. Thanks for the video!
Helpful vid. Thanks
Thanks…