Dash Repair Fix Cracked Dashboard How To DIY Cover Installation

Dash Repair Fix Cracked Dashboard How To DIY Cover Installation

How To Dash Repairs Cover DIY Installation Tips http://www.1OwnerCarGuy.com This is a video of this really cool and rare 94 Nissan 240SX Limited Edition Conv…

45
Like
Save


Comments

Dave Generic says:

Seen those before, but that is a pretty complex one, I wouldn’t have
thought they would have made one for a dash like that….. looks pretty
good… :)

lufc monty says:

that’s shit hot man…looks so good…its amazing how the sun nafs the
dashes up..

Cyberat Rodent says:

That looks better than I thought, I had a 1982 Chevy K10 once, considered a
cover but I thought it would be flimsy & shake loose. How does it drive as
far as rattles ?

mecaniquejp says:

Nice W140 in the background.

ladin425 says:

Nice work, Nate uh, I mean Trent. lol Great product and thanks for
sharing. If you looking for a cheaper alternative but a bit more work,
look into vinyl covering. Daniel Engling has a great video on his channel
showing how he went about doing his 944.

maxx kyritsis says:

If you convert that to a 5 spd manual you could sell it for around $5500
with low miles like that!

aquateen77723 says:

Nice work, Nathan! It looks good. Would it have been difficult to remove
old dash top and screw in this newer one? Keep the repair and beautifyin
tip vids comin’!

YouDontWannaFightMe says:

I bet this car isn’t going to be for sale for long. Cars like these,
especially unmolested ones, are in high demand

dmfub2348 says:

Great job Nathan. Wouldn’t know to look at it that it was a DIY job. Seats
are fantastic. 

Mark Sponge says:

Not a bad fit..

82kyliesexy says:

looks good man 

daniellandgrens says:

Well done Nathan! But the door sound cheap when u close it. Sorry ♡

june201955 says:

Nice job! I’ll bet that you have many vehicles w/dead batteries. You should
try checking out a few vids here on YT about reviving old dead car
batteries, their methods of using dissolved Epsom salts and distilled
water.

1964corvan says:

i dont think i would trust that silicone….. i’d be usesing a 2 part epoxy
of some kind…..but then again you just gotta get it the door. if it falls
off the next day after sold its the customers problem.

Buckswoodshop . says:

Much improved.

dylan davison says:

this looks great

Write a comment