Buy Now!
New Accelerator Pedal & Position Sensor from 1AAuto.com https://trq.video/ia-1AFAC00027
This video shows you how to install an accelerator pedal & position sensor on your 2007-2013 Chevrolet Silverado.
This repair was done on a 2009 Chevrolet Silverado 1500 LTZ 5.3L Extended Cab Pickup 4-Door 4WD Automatic and the process should be similar on the following vehicles:
2007 Chevrolet Silverado 1500
2008 Chevrolet Silverado 1500
2009 Chevrolet Silverado 1500
2010 Chevrolet Silverado 1500
2011 Chevrolet Silverado 1500
2012 Chevrolet Silverado 1500
2013 Chevrolet Silverado 1500
Tools you will need:
• T20 Socket
• T30 Socket
• Torque Wrench https://trq.video/oak7-1AXAA00044
• Gloves https://trq.video/oyQ-1AXSS00048
• Safety Glasses
Subscribe: https://www.youtube.com/channel/UCWCdsftsTqYMO7cA_5Sc-yA?sub_confirmation=1
Check out our playlist:
Chevy Silverado 2nd Generation 2007-2014: https://www.youtube.com/playlist?list=PLJVpHWuCEUX-kpHk3vmpyDsBIEnTo_H6X
⚠ DISCLAIMER:
While TRQ strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. TRQ is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.
){kind=link}
√ Watch the Video
√ Buy The Part at 1A Auto http://1aau.to/m/Shop-TRQ-Parts
√ Do it Yourself
√ Save Money
What is the t20 socket used for?
My favorite account on YouTube
Why the little girl gloves ?
Can u show how to reset sensor
Is this the same connector to add the throttle control module?
Unplug the battery before changing any sensor in a vehicle…
How long does it take?
How can I replace the connector or fix it?
How do I know this is bad ?
How to check those?
Is there a relearn process because I bought one put it in it did not do anyting had to put the old one back in
What would be the reason for replacing this pedal? Do they go bad?
✅Thanks for showing us this but this is not the main issue for these GM trucks from 2007 all the way up to 2014 It's water getting in the back of the dash causing the pedal to go into malfunction and reduce our engine speed where you disconnected the pedal follow the wires up to the fuses and you will see there is rust where moisture is getting into to block off wherever the water is coming from that's the issue that GM knows but does not want to fix
2nd video yet both skipped over reset procedure???