Buy Now!
New Control Arm with Ball Joint from 1AAuto.com http://1aau.to/ia/1ASFK02290
1A Auto shows you how to repair, install, fix, change or replace failing, rusted, rotted, or damaged front control arms. This video is applicable to the 08, 09, 10, 11, 12 GMC Acadia, Chevrolet Traverse, and Buick Enclave.
🔧 List of tools used:
• 21mm wrench
• 24mm Wrench
• 8mm Wrench http://1aau.to/oaT/1AXAA00011
• 21mm Socket http://1aau.to/ohe/1AXAA00043
• 24mm Socket
• 8mm Socket http://1aau.to/ovd/1AXAA00017
• Ratchet http://1aau.to/oEY/1AXAA00016
• Socket Extensions http://1aau.to/oy3/1AXAA00015
• Torque Wrench http://1aau.to/ojj/1AXAA00044
• Rust Penetrant
• Floor Jack http://1aau.to/ohR/1AXAA00068
• Hammer http://1aau.to/oeD/1AXAA00091
• Jack Stands http://1aau.to/ohR/1AXAA00065
For More Info visit us at http://1aau.to/h/abt/
⚠ DISCLAIMER:
While 1A Auto strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. 1A Auto is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.
√ Watch the Video
√ Buy The Part at 1A Auto http://1aau.to/m/Visit-1AAuto
√ Do it Yourself
√ Save Money
Why do you need an alignment?
Is this similar to the 2011 equinox
Why would anyone replace the arm but not the bushing?!?
Excellent video very helpful thanks for your work
I was waiting for you to wiggle the old ball joint to see how bad was it.
I purchased me itch funny Control arms and the bushings stick out too far. How do I push them in to fit into the bracket on my vehicle? I tried a c clamp but was unsuccessful. Any ideas on what I should do? Thanks
Is this for upper or lower control arms?
I'm purchasing a vehicle that has both rear upper control arms loose, rh frontstrut leaking/busted. They insisted it's not something I should be worried about so much and it could be done later on. But I'm not really sure about that. I'm asking for anyone's opinion here. What do you think?
Its a 2011 GMC Acadia.
Couldn't you just place the tire on and set it down to tighen up the last 2 bolts on the control arm instead of using a jack?
It helps when you have a vehicle lift… i dont got a vehicle lift so I cant get the leverage you have.
How to replace just the front bushing?
Great how Too Vids Thanks 1A
Can you replace the lower ball joint without having to replace the whole control arm
Ordered the ball joints from 1A. Got the old ones out (what a pain) and the bolts that came with are a little too big for the old rivet holes. Suggestions?
When I go to tighten the nut on the ball joint, it just keeps spinning. The stud is spinning too. I see a spot for an allen wrench in it but can't get to it to hold it. Is it supposed to spin like this?
can i perform this change with a regular jack stand