DETAILED WIRING TUTORIAL: http://www.youtube.com/watch?v=r4cTNS3GUpc this is the new, REVISED tutorial on how to install leds to the inside of the headlight….
DETAILED WIRING TUTORIAL: http://www.youtube.com/watch?v=r4cTNS3GUpc this is the new, REVISED tutorial on how to install leds to the inside of the headlight….
You must be logged in to post a comment.
')){kind=link}
An easier way to remove the lens is by putting the whole housing in your oven at the lowest it goes. Approx 125 deg C or around 300 deg. F. Leave it in there for about 5-10 mins watching it the whole time it’s in the oven, test it after five mins to see how well it’s working. I’ve successfully opened a dozen or so headlight housing this way. The heat gun is a good second choice but it takes a lot longer to completely remove the lens.
BAIDE OPTOELECTRONIC CO., LTD
IS NUMBER ONE IN PRODUCE :
1- LED STRIP , 2- LED PANLE ( SUPPER SLIM )
3- LED TUBE , 4- LED BULB
NOT OTHERS ( WE CANNOT PRODUCE ANYTHING MORE )
WE JUST LOOK IN OUR JOB , NOT OTHERS JOB
ALL LED STRIP,LED Panel,LED Tube,LED Bulb models are here.
CONTACT ME IN : sales011@baideled.com 86-013825108177
cool idea. plan to do a led install on my car soon
not bad!
Also a little note. try not to experiment with the wiring, dont be cheap and buy a DMM to test which wires have current running through it. You will damage components. Its only OBVIOUS the black wire is ground. this video is quite entertaining. aha
Yeah, it came out pretty nice, with the wiring so the turn signals match the LED strip. But dont toss your headlight lens on the floor. This is why I work on my car myself.
You work very dirty
the turn signal was sick
how do you set up the indicator like that??
Nice walk through!
Dude really? U don’t have to experiment with the wires u get a test light and test the wires its obvious the black wire is ground u only have 2 wires to work with duh
Where did u get the leds? I’ve looked at some and they seem dull.
Time for the grand finally and that shit did’t work lol. He tried to hide that shit. Don’t try that on your car !
Terrible idea! You broke the seal and now your lights are exposed to humidity and they are gonna fog up in the inside and trap moisture. Oh boy…
So complicated @@
Dude, nice mod but be more careful in twisting the cover on the pavement. You should use some newspaper or soft towels to avoid scratching it.
where did you buy the led lights? and where do you buy the heat gun ?
fucking idiot good way to scratch that shit
Doing it on the cement is a good way to scratch the headlight… you did the same side as the side that was done from beginning, why not the grand finale, both completed and done… looks good, and gives it a different look..
its alright good job
THE DRIVER SIDE STRIP DID NOT WORK, THE PASSANGER SIDE WAS ALREADY INSTALLED AND WORKING, DID NOT SHOW US A WORKING DRIVERSIDE LED STRIP!!!! COME ON NOW!!!! MAKE SURE YOUR SHIT WORKS BEFORE YOU SIGN-OFF
nice
If y’all looked closely he didn’t do the driver side. Watch it again.
Do I need a heat gun to remove and replace the housing? If I don’t have one would a blow drier work as well?
running the wire up against the halogen bulb? wouldn’t that melt?
“DYE-YAAAAA! I’M GONNA PUT THIS ON DA CONCRETE FACE DOWN AND SCRATCH THE F OUT OF IT!” What were you thinking?
hahaha….. thats how car mechanics in AUSTRALIA work…