Lol do this on some engines and you’ll need all new valves, don’t actually do this, just get an impact if your purse don’t work
Then you can replace the flywheel too. Noice!
Thank God I never had that problem but that's something that I learned today thank you
All good until u put it on the wrong side then try and its on the right side
Let's hope that it turns in the right direction and doesn't just share the bolt off instead. Also always disconnect spark plugs or HT leads when doing this so the engine doesn't run away
British accent Redneck Engineering
Good way to check the starter did that a few times where the starter welded itself to the flywheel cus the starter had no teeth left.
Don't do this on the ford 1.25 zetec or reanult 1.2 to 1.6 engines…..you will bend valves
After you losen first guys , break your starter ? Or flywheel ?
Comments are disabled for this post.
){kind=link}
Lol do this on some engines and you’ll need all new valves, don’t actually do this, just get an impact if your purse don’t work
Then you can replace the flywheel too. Noice!
Thank God I never had that problem but that's something that I learned today thank you
All good until u put it on the wrong side then try and its on the right side
Let's hope that it turns in the right direction and doesn't just share the bolt off instead. Also always disconnect spark plugs or HT leads when doing this so the engine doesn't run away
British accent Redneck Engineering
Good way to check the starter did that a few times where the starter welded itself to the flywheel cus the starter had no teeth left.
Don't do this on the ford 1.25 zetec or reanult 1.2 to 1.6 engines…..you will bend valves
After you losen first guys , break your starter ? Or flywheel ?