http://www.ClassicVWbugs.com This is a short video on how to replace your rear torsion arm bushings for early swing axle VWs.
http://www.ClassicVWbugs.com This is a short video on how to replace your rear torsion arm bushings for early swing axle VWs.
You must be logged in to post a comment.
so lets just say, i have this “friend”… that took the torsion arms out
without marking where they are suppose to go back in. Any advice on how to
put them back in without the reference marks?
Omg man please help! you skiped the part where you take out the splines and
where you put them back please can you help i have stripped splines and i
want to change them but all the vw mechanics say u have to take the eng and
trans out and they said it cost like a grand for an estimate plsase help
you took it off like in a second but you didnt show it please tell or show
i need to know this because i have school! Thanks in advance
Great little how to video, check it out…http://ow.ly/l1OAS
Ok cool. Thank you.
C clamp is a good idea to get the caps on. I just use two longer bolts,
opposite corners, to tighten down the cap. Then I put the regular sized
bolts in on the other two corners and tighten those down. Next, I back the
first two long bolts out and replace them with the proper sized shorter
bolts. Done.
Christ, I think you should do a video about changing the link pin bushing.
I am really unable to find a quality video that show me step by step how to
do that. Thank you!
Btw, thanks Chris! Great video as always!!!
awesome video Chris
wheel bearing grease.
Do you have a vide on doing this to an IRS bug? Thanks for the video.
What type of grease do you use ?
You should mark the arm position after releasing the pre load on the
torsion arm!
nice video
You should mark rocker arm by removing the lower part of the frame not
before. it is important to tension springs and the height of the vehicle
3:30
Chris, Thanks thumbs up Ron
Nah I just did this one so far. I will soon!
irs will be the same procedure
Hey cris! I need help I don’t know how to remove my upper ball joint. How
do I remove the ARM? It’s under pressure right? Help me man ASAP.
Really helpful video, i would like to know how to align rear axle because
my VW rear end is higher when drive rearward than forward.
You are welcome man! Thanks.