Rebuilding Toyota Hilux 2nd Engine- Toyota Hilux Engine Restoration |

Rebuilding Toyota Hilux 2nd Engine- Toyota Hilux Engine Restoration |

Rebuilding Toyota Hilux 2nd Engine- Toyota Hilux Engine Restoration |

314,172
Like
Save


Comments

Z pasją do mechaniki says:

Gdzie klucz dynamometryczny?Gdzie dokręcanie zalecanym momentem i kątem głowicy,korbowodów…….

Stewart Gani says:

Oh dear Lord, I have the exactly the same Mitsubishi Triton at the back there….

Allan Prestado says:

If there is no youtube they will not do this video

Rutab Qadeer says:

pakistan zindabad

Leo Ramirez says:

Admire everyone puts hands on the engine also worries me lol great team work regardless.

chehuicho says:

no torque parameters? bad rebuild

Anton B says:

Смотрю на всё это и думаю,зачем я 5,5 лет в университете учился…..

İbrahim Aydin says:

what ıs this man 20 people engine bruh fuck this engine

qwert3935 says:

Ремонт от замены до замены масла, ибо масло не меняется вообще

Napalm Man says:

No torque wrench, man…

Igoryan says:

А я думаю что мой мотор ни едит

Nhat Nguyen says:

Lực siết rất quan trọng

Coolie Montages says:

I’m dying to know how much does this rebuild cost in labour?

Аркадий Самородов says:

Странно что у них гусь не самодельный, хотя…

Phuoc Nguyen says:

that is how car shop was back in the day with out all the high tech machines but the way they surface the engine i dont know about that pr that when the shop owner teaches them young kids about rebuilding motor but really they doing all the labor free lol lol shop ower happy

Dan T says:

How do I make an appointment to drop off my '06 Highlander?

leeit2me says:

torque wrench??? what torque wrench. LOL.. we tighten by feel..

Mussa says:

I know these engines, the cracked head is a casting error from Toyota in my opinion. But a rebuild like this will never do 500k like a factory build.

What the hell did they put on the head gasket?

PS and in the end they never started the engine on camera, I wonder why?

Timothy says:

The sandels in a machine shop kill me

Ernie Delafuente says:

I noticed they don't use torque wrench when tightening the main bearings and con. rods!

Comments are disabled for this post.