hey, awesome video,im gonna be doing this Sunday, Ive done it before but
its been like 10 years,can i reuse the nut or do i have to get a new one
and if i do where do i get it? part store? also when i remove the dust
shield more than likely it will be destroyed,can i get one at the part
store like the nut? thank you for your time!!!
Dade line find a tool that fits the center of the bearing and press that
out the hub will be attached to that piece then you take that dust ring out
, next take the snap ring out, then you press the bearing from opposite
side, now you’ll have the hub with part of the bearing still attached, use
an air grinder with 2 inch cut blade, cut a diagonal line across that part
of the bearing on the hub be careful not to damage the hub once you’ve cut
through it use a chisel and break it off
pain in the ass bolt!
thx sir!
That’s the way to take that nut out!!!!!! THANK YOU VERY MUCH VERY
HELPFUL…
Thanks for this; just got myself a 2009 Camry with bad front bearings.
George it’s 1 single bearing and there is one dust seal..
Are there oil seals required for this bearing? is it inner and outer?
Thanks
hey, awesome video,im gonna be doing this Sunday, Ive done it before but
its been like 10 years,can i reuse the nut or do i have to get a new one
and if i do where do i get it? part store? also when i remove the dust
shield more than likely it will be destroyed,can i get one at the part
store like the nut? thank you for your time!!!
Found 30mm 12 point that did the trick at Lowe’s
Dade line find a tool that fits the center of the bearing and press that
out the hub will be attached to that piece then you take that dust ring out
, next take the snap ring out, then you press the bearing from opposite
side, now you’ll have the hub with part of the bearing still attached, use
an air grinder with 2 inch cut blade, cut a diagonal line across that part
of the bearing on the hub be careful not to damage the hub once you’ve cut
through it use a chisel and break it off
I wish I could see you taking the bearing off and pressing it I think I
might need to change my Camry’s bearings.