Suzuki SJ413 Samurai Jeep – Floor Rust Repair 1 of 3. One place a Suzuki SJ413 Samurai or Jeep will rust out is the floor because rain water or mud can accum…
Suzuki SJ413 Samurai Jeep – Floor Rust Repair 1 of 3. One place a Suzuki SJ413 Samurai or Jeep will rust out is the floor because rain water or mud can accum…
You must be logged in to post a comment.
Typo /on that metal it will hold till the jeep falls apart u will not even
have to spot weld it No shit BS
Look up marine epoxy adhesive it’s called 5200 if u put that om
Use stainless steel rib it’s mr$ I’m glad to c u r using a template u need
a plasma cutter go bye a mom and pop auto body shopp they will cut it 4 u a
empty gas tank is more explosive than a full tank u can throw a lit
cigerate in it and it. Will go out my dad proved it to me
Hey asshole any car ect ect with a short wheel base will flip very easy do
not cut the wheel hard and u will.
Yes, I know. I had this SJ413 almost since new. It has well over 220,000
miles on it and it runs like new.
you know those suzuki Samurai’s have a high flip rate, other then that
theyre good jeeps
I decided to order some 3M copper weld through primer and apply it before I
weld. I want this to be more rust proof than when it was new and stronger.
Yes, true or the copper stuff too.
cold galvanize rattle can weld right over
You’re right. That would work too. I’m going to weld this in though. I’ll
put chassis saver over it and construction adhesive as a seam sealer. Later
I will use truck bed liner on the whole floor. I had this SJ413 almost
since new and rust-proofed it a lot before. Not much rust as all. But this
next time I will make it so it never will rust again at all. I hate rust.
🙂
If you can find an old road sign those work great , easy to cut form and
shape for the floorboard. I used sheet metal screws to tack it down with a
rubber gasket I made and it works great.