Fog light install 2011 Subaru STI

Fog light install 2011 Subaru STI

Installing my OEM fog lights (does not include toggles switch install)

21
Like
Save


Comments

Stefan Van Braam says:

Thanks for the informative video. Hope to see a toggle switch video.

Daniel Arias says:

U should do a vid for the jdm third brake light…

AWDMASTI says:

It’s totally unnecessary to take the bumper off. Just jack it up and go under it.

Treehouse1230 says:

Props to the poster for doing a good install video. Definitely a good way to do things, however, I have found an easier way to go would be to simply remove the bumper cover. Takes a few minutes to remove and re-install and gives you full access to all crucial areas. Just fyi.

Phok3r says:

hey was that wiring harness for the fog already inside the car and not connected to anything? or did u have to wire that through yourself. oNly thing stopping me from ordering asap is the work i would have to do to wire it through myself.

jesuitraiders says:

Hey, I just ordered a 2012 WRX without fog lights but I am considering putting in an aftermarket/OEM set. I am out in Brookline, MA.

Januch009 says:

led’s* not less

Januch009 says:

hey do u know how to take a part the light switch inside the car to turn the lights on becuz I’m putting my own footwell less in and want to tap into that to make my lights turn on when the fogs are on

AWDMASTI says:

The electrical isn’t too bad. Just hard to get at some of the screws. If anyone in MA wants me to help them out I will. I can do this in under an hour now, and we can get video.

Jerraiah Magsanoc says:

please keep us updated man. ON the electrical to. Show us the whole set up. Ur helping me me so much by doing this. We appreciate it Thanks!

Write a comment