Saturn Vue wheel bearing replacement
Facebook
https://www.facebook.com/BackWoodzcustomz15/
Instagram
https://www.instagram.com/backwoodzcustomz15
You can support us by using these links to our decals
http://stores.ebay.com/BACKWOODZCUSTOMZ1
Saturn Vue wheel bearing replacement
Facebook
https://www.facebook.com/BackWoodzcustomz15/
Instagram
https://www.instagram.com/backwoodzcustomz15
You can support us by using these links to our decals
http://stores.ebay.com/BACKWOODZCUSTOMZ1
Comments are disabled for this post.
Now if I can't get off the top bolt I'm a girl by the way what do I do I refuse to take it to mechanic I wanna do it myself guys I got her all broke down though
What are the torque specs?
A weighted slide hammer and a front wheel drive bearing remover cost about $200 at harbor freight but will do the job in about 30 min. I don’t support harbor freight but I do support the right tool for the job.
When I look this up I wanted to know what the torque specs were and they never gave Them I blame it on Google more than anything
Good to no thank you
What is the torque thing called you had to use to tighten it at the end ?
What size is the socket?
Couldn't you just use a quality 3 jaw puller…..the CV-axle has the divot for the screw part of puller. Just place the 3 jaws around the outside of hub (where the studs are).
hey back woods watch this below this is what i came up with what do you think
My 04 Vue is the same right now. I don't have a touch like that. Sledgehammer and chisel isn't budging it.
I have replaced at least a dozen wheel bearings on GM cars and trucks, and my 2006 Vue was the only one that I had any problems with. Usually the bearing nearly falls out when the three hub bolts are removed. Not this time. Over three hours of beating on the old bearing and a trip to Lowes to buy Map gas, and not one lick of progress. I wound up removing the steering knuckle and beating the bearing out from the back side. Yes, an alignment may be necessary afterwards, but the bearing would not budge otherwise. Took about 10 extra minutes to remove the knuckle completely, and about 5 minutes of beating with a 4 lb sledge, but it is out and done.
Thank you for an Awesome informative video, lots of detail and professional. Thank you
I like that bolt through the stud hole technique to make a puller trick. Did the same job on my 2008 Vue and it was a real pain to get mine out as well. Toughest mechanical job I ever had to do!
Just buy the wheel bearing tool geez hurts to see this kind of work.
they should have used anti seize when putting it together in the first place !!
did you use any lube on the shaft??????