http://www.1aauto.com 1A Auto shows you how to remove or replace the interior door panel trim on your vehicle. You need to remove the door panel for a number…
http://www.1aauto.com 1A Auto shows you how to remove or replace the interior door panel trim on your vehicle. You need to remove the door panel for a number…
You must be logged in to post a comment.
You may have to so that you can access the screws. 1aauto.com 888-844-3393
You may have to, so that you can access the speaker screws. 1aauto.com 888-844-3393
I saved myself a lot of work and just slid the rear deck interior down the seat belt. It at least exposed the whole rear deck, so it’s good enough for me
There is a large bolt that is located under the rear deck lid. You will have to remove the head rests as well to gain enough access to the seat belt bolts.
how would I go about doing that? A bolt in the trunk?
To properly access that area, you will need to remove the seat belts.
What about the rear speakers? Do I have to remove the seat belts to take that whole panel off to get to the speakers?
Yes the entire door panel needs to be removed.
I’m trying to swap out all the speakers in my ’05 Ion 3, do I have to remove the whole panel to replace the door speakers?
Hi John, You may want to take a look at the switch on the door jamb to see if it needs to be replaced. Hope this helps you out.
Hi Mike, can you tell me why the chime is on my 2007 Saturn Ion? The driver door opened only the chime stays on, key out and all lights are off. Only driver door does this. Please help, thanks, john in NJ.
Do you have a video on how to change out the motor for the power window once you get the door off
Once you remove the window crank handle, you should be able to apply most of this video to your vehicle.
How do you do this if you do not have power windows on the car. do you pop it off or does it have any screws hidden that can be stripped that are hiding in the window knob
Saturn Ion 2007 level 2
We have a video that will show you how to remove the window crank handle. Copy and paste this code dnmPVf4KNcw into YouTube search.
You could use a putty knife too.
Do I absolutely need a door clip tool? Or can I get away with a flat-head?
You may be able to.
I have an 07 it doesnt have the first clip shown closest to the door latch. Can i take the panel off?
can u upload a video with a manual saturn ion 2003…need to install speakers but i cant unistall the front door window nob,….please…..
It would be the same but for the manual one you will have to remove the C-clip for the hand crank.
I noticed the model you were doing this with has automatic windows. Mine has manual window control. What would be the procedure for removing the door panel with that on? It has been an ongoing battle to figure out as my two front speakers are blown and im trying to replace them.
Thanks, ill try but there are some screws i cant get to. ill let ya know how it goes
You may need to remove the door panel and reach inside the door to see if you can pop the door open by hand. If you tug on the rod it should open for you, then you can fix the handle issue. Hope this helps you out.
what if the door wont open at all? inside or out
You may want to check the door jamb switch to see if anything is corroded that could cause this, or you could try to pull the headlight fuse, dome light fuse etc. while the chime is going off to try to narrow down what may be causing this. If your at a total loss, you may want to join a Saturn message board and post a thread about your issue to see if any fellow Saturn owners with your year make and model have experianced the same thing. Hope this helps you out.