Hey, how’s it going? Welcome to Big Blocks channel.
In this video, we’re installing an oil pan gasket in a 2005 Pontiac GTO. The method I used involves supporting the engine while dropping the subframe, saving a TON of time.
Have any questions? Drop them below in the comments section.
Check out Taylor’s channel – https://www.youtube.com/channel/UCgrpw0wCaE85DQXeFER9MAg
You can’t just let the rack sag ?
Nice job kid!
Ouch, that is a neat lifter but I've seen some fail on other youtubers. I would probably put some jack stands in case it fails.
You didn't do the oil pump pickup tube should of done it while in there
How many hours it take
If you lower the cradle just enough for the pan to clear when removing, how much of the suspension actually needs to be un-done from the cradle? Can most of it be left together?
Knocking nose !!!
All that got oil pan great !
Where did u place the quick jack, on pinch weld?
Great video man! 2 questions for you, (1) Did you do cradle alignment after? Lastly, what wheels is that? I’ve been looking for that brand but can’t find it. Thank you!
This seems a lot easier than lifting the motor out and shimming it back and forth both times, pulling it out and then putting it back in. Best of all looks like this way it can be done by 1 person.
Quality work and viedo