Watch a full tutorial as a 2000 Pontiac Firebird will have a brand new eRapta License Plate Backup Reverse Camera installed. This camera will be installed to an existing double din aftermarket radio.
This video applies to Pontiac (and some Chevy Camaro) models for years 1993, 1994, 1995, 1997, 1997, 1998, 1999, 2000, 2001, and 2002. This video also wiring, installation, and testing.
Click here to see the Radio install video:
https://youtu.be/RHuC_PcxGC0
Click here to see the Amplifier install video:
https://youtu.be/l1f1NxBq3iI
Click here to see the front speakers install video:
https://youtu.be/NYEK8gFKI0I
Click here to see the rear speakers install video:
https://youtu.be/mZ3izNQ_3ek
If you have any questions, leave a comment below! Be sure to like and subscribe!
Backup Camera:
*eRapta ERT01 Reverse Camera (presented in a separate video)
Radio Install Parts Used:
*Metra 95-3312G Double DIN Dash Kit
*Metra 70-1858 Radio Wiring Harness
*Metra 40-GM10 GM Antenna Adapter
*Metra Axxess ASWC-1 Steering Wheel Control Adapter
*Pioneer AVH-1300NEX
*Microbypass
*Remii AUX / USB Flush Mount Relocation Kit
You obviously know your stuff! here's a challenge for you if you offer tech advise. Wife's car 97 base firebird convertible. there was a 2 din in there wanted a newer version without cd went with a 2 Gg 32Gg RK-A715. My problem is, I had to butt connect & soldered & heat shrink colour codes as per diagram from radio" since previous owner had cut factory connector. I followed everything as one would, radio boots , plays awesome on acc. key mode + back up camera works but when I turn ignition to on, the screen goes out & sound cut as well, like wtf ! I know probably a simple fix but?? Thanks,
How do you get it to trigger when in reverse? You don't explain that and I can only get it to turn on by manually turning it on from the deck
Got a question on hooking camera up with its on switched power source so that you can activate it when u want. I hooked up a switched power source off of radio but the camera stays activated all the time once you select the camera on the radio. How can I get camera to only come on when selected?
You are not clear on the power source for the camera
Is the wiring similar to a 2002 sunfire?
Great vid! Could I do this on a 1992 Camaro?
What wire did you use to extend the power to the camera from the radio
Very informative and well done, we will be at CES please subscribe to us.
That's awesome, I'm considering getting a 2001 firebird and adding something like this.
Where did you get power? I know you mention that it's from up front, but not sure where. Also, I have a cd changer in the rear that I will be removing. So can I use power (red wire) from that?
Great video, Can the camera be connect directly to an aftermarket amp power? And ground to chassis. So all that would be needed from radio to back is the trigger wire and camera rca?