Fixing an oil leak on a 2007 Peugeot 307 1.6 HDi
I noticed when i had this 307 in my shed that it marked its territory with gearbox oil on the ground. Also when changing the brake disks i noticed that the front passenger side CV boot was loose and grease was beginning to escape.
Both the CV boot and the driveshaft oil seal combined cost less than £20. I am doing the work using a jack and axle stands because the 305 getting the turbo diesel conversion is on the lift. However using a jack and axle stands gives a view more akin to what most DIYers will be doing. This is definitely a job that can be tackled DIY and should greatly increase the service life of this car.
What socket size do you use?
Exceptional video!
Very clear step by step instructions and added advice.
Why would you change the ball joint only, change the whole thing man, it will cost 30 extra
hi my friend, very good explanatory video, just wondered is the gearbox oil filler located in the same place on a 308 SW 1.6 hdi, regards billy
Que paso con el cambio de motor al citroen xantia
Good job
If u can show us more about 406
Notice the number plate is an illegal font and may fail an MOT