Shop for New Auto Parts at 1AAuto.com http://1aau.to/c/216/z/license-plate-lights
In this video, 1A Auto shows you how to replace a broken, damaged or burnt out license plate bulb. This video applies to the 12, 13, 14, 15, 16, 17, 18, 19 Nissan Versa.
🔧 List of tools used:
• 10mm Socket http://1aau.to/o2G/1AXAA00017
• Needle nose pliers http://1aau.to/on2/1AXAA00051
• Needle nose pliers http://1aau.to/on2/1AXAA00052
• Ratchet http://1aau.to/oari/1AXAA00016
• Gloves http://1aau.to/oei/1AXSS00048
For More Info visit us at http://1aau.to/h/bsv/
⚠ DISCLAIMER:
While 1A Auto strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. 1A Auto is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.
√ Watch the Video
√ Buy The Part at 1A Auto http://1aau.to/m/Visit-1AAuto
√ Do it Yourself
√ Save Money
This video needs to be re-titled, 2012-19 Nissan Versa SEDAN. These instructions do not apply to the hatchback Versa at all.
Too much work for simple bulb change ! Great engineering Nissan!
I feel like Beavis and Butthead laughing at 3:45
All you have to do is pry out the little black plastic well from the outside and change the bulb. No need to take all of that off the trunk.
Whats this too hard job for only one bulb it should be factory made it easier because the bulb is burnt most of the times actually they didn’t want you to do it by yourself you have to take car for mechanic every single times
Thank you for the steps. I have a 2019 Nissan Versa S Plus. I had to use an 8 mm socket since 10 mm was to big for the nuts. I replaced the two license plate factory bulbs with T10 LED bulbs. Also the trunk lid had a liner. I needed to remove all the fasteners holding it in place using fastener removal tool.