Here is a short tutorial on how to take apart a Mitsubishi ductless mini split for cleaning or repairs. It is a pretty simple process once you have seen it done a few times. This is the process I use to deep clean these units, general maintnenace or perform many repairs. Maintenace on a ductless mini split is critical to keep up its performance.
Be sure to check out our Amazon storefront to see all the products and tools we use. This also helps our channel grow!
https://www.amazon.com/shop/hvacinsc
')){kind=link}
Great video! Thanks!
Drain pan!? So much better than the Mitsubishi video
Very good video. I appreciate the attention to detail!
Hello Sr. Can't u tell me where the yellow cable for the water go please I clean the equipment buy it forgot tks
Thank you so much!
excellant. great tips. saved LOTS of time
This video was so helpful, thank you. My only extra note that was not covered in this or other videos I watched-When you replace the blower wheel, it has some play and can shift left and right inside the unit. You need to get it in a position where it doesn't rub or make any noise while spinning, then tighten the set screw to secure it in place.
Too difficult
Adding to the chorus of thank yous–I watched multiple videos and you're the only one that explained how to detach the top part of the cover. It still wasn't easy, but i got up there and pushed down along the back top of the cover until I depressed the clips.
Skipped steps.