How to repair P2004 and P2006 tumble flap inlet manifold codes. This video will show you how to replace the intake manifold and show you what fails. The vehicle is a 2008 Mercedes Benz E350 211 with a V6 engine.
Parts purchased at. https://www.autohausaz.com
){kind=link}
I like the way you did this video Man…Thank you
Great video helped me a ton I would suggest when disconnecting old manifold it is easier to disconnect vacuum hose from change over valve from yellow plastic hose instead of disconnecting it from manifold itself. Mine was stuck so bad and I was afraid I will break the hose so I disconnected it from change over valve to the left of the engine then you can feed it back when reinstalling and reconnect it.
Hi Nicoya, great detailed video! Just making sure, but you used the URO repair kit, right?
Why didn’t you show how to replace the frikken runner flaps ugh what a waste of a video
Great video. I also have a broken actuator arm on a 2007 C280. My question is "Is it necessary to replace the entire intake manifold if all I need to do is replace the actuator arm with an aluminum one?"
So when that code comes u need to change the whole thing or actuator only?
Great video, i have. 2009 that has a misfire in cylinder fove, changed injector/coil/spark plugs still getting the misfire. Do you think this will be fixed with a new intake manifold?
Great video. I bought the kit as well but I broke the tumble flap mounting screw off inside the manifold and ended up buying a new manifold. I'd like to install the aluminum bracket on the new manifold but I'm afraid to remove the actuator screw off the new manifold. Did the screw back out easy for you?
Does anything have to be reset on these Mercedes
Got the same code, but all rods and levers are fine.
@Nicoya…Peace & blessings! What silicone did you use to keep the gaskets in place. Did you use it on the whole gasket?
From Atlanta Thank you very much sir for this video
I have 2008 E350 with code P2004.
Excellent video.thankyou
Hi what are the torque specs for the throttle body to intake and the intake to cylinder
Nicoya, this is the best comprehensive video and I have seen for this kind of repair. I will do as I see here and start wrenching. Thank you for sharing. This will help save some funds.
Ahh so Mercedes goes all out on the interior and tech, but cheaps out under the hood. Gotcha!
Great presentation, excellent on all fronts!
question, why you rather put a new manifold instead of using the repair kit which has the update plastics to aluminiun ? i just got the code p2006 and my manifold was replaced by previous owner 50k miles ago and now i am thinking just to replace the plastic piece to aluminium. please advise
I'm getting this done on my 2012 GL 450 right now. About $1875 parts and labor with my indy mechanic. 🙁
Great video, it helped me complete this job at home with zero issues.