How to Replace Valve Cover Gaskets on a 2005 Mercedes C240

How to Replace Valve Cover Gaskets on a 2005 Mercedes C240

Brian Eslick from How to Automotive http://www.howtoautomotive.com takes you step-by-step through the process of replacing the valve cover gaskets on a 2005 Mercedes C240. Estimated repair time is 3.50 hours.

Affiliate link mentioned in the video for Victor Reinz VS50432 Valve Cover Gasket Set http://amzn.to/2i4NIUl

Affiliate link mentioned in the video for URO Parts 112 018 0482-PRM Breather Hose http://amzn.to/2h1g2LC

Affiliate link mentioned in the video for URO Parts 112 018 0282 Breather Hose http://amzn.to/2hJYsJ2

Affiliate link mentioned in the video for Vaico Breather Hose http://amzn.to/2hP7V1l

Affiliate link mentioned in the video for Permatex 29208 The Right Stuff Gasket Maker, 5 oz. http://amzn.to/2hP7Drl

Website
For more videos, tips, and to purchase recommended tools and products visit my website at: http://www.howtoautomotive.com/

Stay connected at:
Email: howtoautomotive@gmail.com
Facebook: https://www.facebook.com/How-to-Automotive-432536836946801/?ref=settings
Google+: https://plus.google.com/+HowtoAutomotive/posts
LinkedIn: https://www.linkedin.com/in/brian-eslick-819839118

Disclaimer
Owing to factors beyond the control of How to Automotive/Brian Eslick, it cannot guarantee against unauthorized modification of this information, or improper use of this information. How to Automotive/Brian Eslick assumes no liability for property damage or injury incurred as a result of any information contained in this video. How to Automotive/Brian Eslick recommends safe practice when working with power tools, automotive lifts, lifting tools, jacks and jack stands, electrical equipment, blunt instruments, chemical lubricants, or any other tools or equipment seen or implied in this video. Because of factors beyond the control of How to Automotive/Brian Eslick, no information contained in this video shall express or imply warranty or guarantee of any particular result. Any injury, damage or loss that may result from improper use of these tools, equipment, or information contained in this video is the sole responsibility of the user and not How to Automotive/Brain Eslick. #howtoautomotive

6,489
Like
Save


Comments

Yung Just says:

my car is running hot and i notice oil coming from the top of the gasket where the silicone goes. can this cause your car to over heat with out a check engine light coming on . it only said check antifreeze but went right away and the antifreeze is full

ICEFOOL says:

important question. I replaced 4 breather hoses on my 2002 c240 and the one hose in the back driver's side part of the engine had 3 ports. 1 on each end and 1 sticking out of the side of the hose. the part number on the old hose is A 112 018 0682 the new hose I got in the mail only had 2 ports, one on each end. the part number on the new hose is a 112 018 0482. I'm wondering if that part has been revised to where I just plug the nipple that goes into the 3rd port on the old hose and just slap in the new one.

ICEFOOL says:

hey, the mass air flow sensor bracket on my 02 c240 mercedes is broke and i've looked everywhere on the internet for a new or atleast a used one and can't find nothing. do you have any ideas where i could get one?

itsa mei says:

how long did this job take? great job by the way

الجورني الليبي says:

it really helps . thanx for this video .

STEVE ROB says:

Well done. Cheers

Write a comment