Thanks for great video, have a question: did you use proper torque settings or just used torque wrench on maximum? i have just impact wireless wrench with max 700 ft/lbs will i break something? thanks
Thanks so much for the speedy reply. 30 minutes per side is not too bad. I have very slight play when I move it with my hands placed my hands in the 3 and 6 clock position. But nothing in the 12 and 6 o’clock position. Have you replaced any of your upper control arms? Did you have any growling when your truck was in motion? Thanks again for everything.
Thanks for great video, have a question: did you use proper torque settings or just used torque wrench on maximum? i have just impact wireless wrench with max 700 ft/lbs will i break something? thanks
What size of rims and tires you have?
Nice video brother! thanks! Tackling mine in 3 days. Lol
Thanks for the great instructional video Gus! You explained everything I needed to know to do this job myself.
How not to change the easiest Bearing ever
How’s your lucky 8 wheel hub holding up? Any complaints?
Thanks so much for the speedy reply. 30 minutes per side is not too bad. I have very slight play when I move it with my hands placed my hands in the 3 and 6 clock position. But nothing in the 12 and 6 o’clock position. Have you replaced any of your upper control arms? Did you have any growling when your truck was in motion? Thanks again for everything.
I am not mechanically inclined at all, but can a non- rover mechanic perform this job? Thanks again. BTW, how long did the job take you?
What you can do to make hub removal easier is just thread the bolts into the hub from the rear and use your hammer.
Use a air chisel
Use a stronger gun
Should have put copper grease on the bolts before refitting, and fitting the hub.
Also would have replaced the brake discs and pads at the same time.