www.classic2current.com helps restore a 1996 jeep classic in need. floor pans and rear cargo. thanks you dale, jeffery, kelsie for all the help. visit www.c2…
www.classic2current.com helps restore a 1996 jeep classic in need. floor pans and rear cargo. thanks you dale, jeffery, kelsie for all the help. visit www.c2…
You must be logged in to post a comment.
didn’t remove the gas tank. just becareful.
Did you remove the gas tank before welding up that rear panel?
I didn’t know you could get to those frame rails so easily like that.
Real rock crawlers would benefit greatly from boxing that bad boy in and
maybe even adding some gussets here and there, Before boxing it.
OMG is this truck from the Salt Lake City area of Utah? The massive salt
over there KILLS cars. Ive had friends drive there to get good deals on
used cars not putting 2 and 2 together and finding out there is tons of
body work done or needed to be done. Usually the body work done to repair
body cancer in that area is slap dash get it in and out fast type work.
They also make complete Left/Right floor pans (covers front all the way to
rear, but not cargo area) so you don’t have a gap to weld shut.
Hi! I wonder if you know where can i purchased de part that we see a 4:12
that de front bolts of the seat bolt on? And whats the name of that piece.
Mine are rusted too so i cant just install new pans…thanks
How do you install the seats?
is this the same company that has the ebay store selling xj body panels?
Thanks alot. I will start my collection.
Yes same company
all lower plastic needs to be removed from the interior. Buy black paint to
paint the bare metal and fresh weld spots. and some undercoating for the
bottom of the floor pans once installed.
Maybe a flux core welder TIG/MIG will work.Tools, air chizzle to get under
the floor pans to remove factory spot welds that hold the floor pans in.
Wire wheel to remove rust and reveal new rust free metal to weld. A rust
equalizer royal jelly” rust remover with a paint brush .Some sealer to seal
the floors after welding waterproofing “liquid nail” sealer is good. angle
grinder or cutting wheel to remove rusted floor. remove seats, carpet,
center console and all lower kick panels
I mean items.
Thanks for the tips
Check eBay. I got my floor pans from there.
I have just purchased a 93 Cherokee sport and after removing the carpet i
found a crappy patch on the drivers floor pan, as well as a gaping hole in
the passenger side rear pan. I felt hopeless and was ready to junk it but
all the major stuff works like a champ. After watching your video i see a
glimmer of hope for this Jeep. Thanks for posting!! By the way, i don’t
have access to a lift, is it possible to repair these itemp without it? I
would appreciate a response. Thanks again.
do they still have the rear floor pans i went on the site but cant find it
and i need one
Thanks man!
I wouldnt call a 96 vehicle old, but thats some wicked rust, ive got a 05
liberty hope its not the same in 9 years, good job with the tidy repair
We welded the seat brackets back in. After the floor pans. Just like OEM
We did it all with no lift. Just lifted it up to look at the bottom…
Bought a couple of Rocker Panel replacements from these guys for my 97 Jeep
Grand Cherokee. Worked perfect. Cut out all the rust, built the inner panel
and welded up the panels that I got from these guys. Saved me a bunch of
dough.
Don’t give up hope. you can buy all the floor pans off eBay. Or at c2c
website.
Yes I also have a 95 that needs this…was removing anything else beside
seats/carpet neccesary? Also what welder would you recommend and tools?
Please thanks like and subsridpbed.