Gmc front wheel bearing noise fixed replacement guide #automotive #diy #garage #mechanic #trick

Gmc front wheel bearing noise fixed replacement guide #automotive #diy #garage #mechanic #trick
0
Like
Save


Comments

@myopinion8753 says:

We get it, it doesn't spin very good. But keep trying.

@green6528 says:

А почему нельзя просто поменять подшипники?

@Einherjar_17 says:

Ni siquiera quitaste el oxido, ni limpiaste nada, este video es sobre lo que esta mal hacer?.

@SomeCajunDude says:

I guess you get what you pay for.

@christopherpelton725 says:

That all came off way too easily. Here in the rust belt, that wheel hub assembly would have been rusted tight to the steering knuckle and the tie rod end would have never come out that easily either.

@stan5513 says:

He's trying to beat the book time.

@felixr7569 says:

Como está el brazo de dirección!

@a95569 says:

So many "experts" spouting so much garbage. These know-it-alls should either create their own channels or stfu!

@RigobertoDimas-r3z says:

So I guess torque the hub bearing bolts and the axle back to factory specs was optional this really pisses me off when I see these young mechanics do this this is what you call a lazy mechanic because I was working on cars 47 years now experience in every single bolt nut washer I'll always reinstall it back to factory specs because this is the proper way to do it not half ass

@Houndini says:

I hate them set-up’s. Give myself the older Fords take the hub off & pop a drill hole between the bearings with a install grease fitting & give it couple pumps of good grease. I feel my hubs at least once a week if they are running hot.

@krzysztofstepien9283 says:

Za mocno piaste dokrecil

@chung-heehan3723 says:

메이드인 코리아 일진 이네 ^^

Comments are disabled for this post.