How to Replace Front Inner Tie Rod 06-10 Ford Explorer

How to Replace Front Inner Tie Rod 06-10 Ford Explorer

Buy Now!
New Tie Rod from

1A Auto shows you how to repair, install, fix, change or replace a broken, busted, bad, or damaged tie rod. This video is applicable to the 06, 07, 08, 09, 10 Ford Explorer or Mercury Mountaineer.

🔧 List of tools used:
• Pry Bar
• 17mm Wrench
• 19mm Wrench
• 21mm wrench
• 22mm Wrench
• 17mm Socket
• 19mm Socket
• 21mm Socket
• 22mm Socket
• Needle nose pliers
• Needle nose pliers
• Pipe Wrench
• Side Cutters
• Vise Grip Pliers
• 1/2 Inch Breaker Bar
• Ratchet
• Socket Extensions
• Torque Wrench
• Anti-Seize Grease
• Marker / Writing Utensil
• Rust Penetrant
• Center Punch
• Floor Jack
• Hammer
• Jack Stands
• Pick

For More Info visit us at

While 1A Auto strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. 1A Auto is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.



Jason Soto says:

When I took my boot off it leaked a lot of power steering is that normal?

ThothHeart Maat says:

Where you get that boot clamp?

DRP SW Ohio says:

Mine is an 05, everything looks the same as far as I can tell. Do you know if there's any differences? I can't find a video covering mine.

agus hipolito says:

I mean why did you Mark the old nut for?

nygcomp says:

Awesome thanks for the video ….very easy to understand ….

Comments are disabled for this post.