Chris Duke from Motorz TV http://www.motorz.tv/ shows you how to install an ATI ProCharger supercharger on a 2008 Ford Mustang GT. Special appearance from AT…
Chris Duke from Motorz TV http://www.motorz.tv/ shows you how to install an ATI ProCharger supercharger on a 2008 Ford Mustang GT. Special appearance from AT…
You must be logged in to post a comment.
Easy as fuck.
They send the mechanic in the box with the supercharger lol
Omg !!!! A pro charger goes on the side and the super charger goes on the
top a pro charger and a supercharger are soo different
if I’m going to spend that kind of money for the system I would want a fuel
pump that does not just strap to the sending unit that was really cheesy, I
have 98 Pontiac with a super charged 3800, I installed a walboro 90 psi 260
lph fuel pump a hole lot easier then what was done here.
hi man i have a question where do i put supercharger before or after
carburotor and why ???
LOL mass air extender what a tool theres no such thing it modifies the
signal to trick the ecu.
I would imagine he’s promoting Craftsman tools.
I have a question how much does the transmission cost
How often do you change the 6 ounce oil on that thing? Do you even change
It??
lol Sears does superchargers now?
the tension arm roller hit its own bracket when he lets off the throttle…
poor clearance issue….@ 16:46
110 hp increase? lmfao
Can you guys do a kia soul upgrade??
one thing that they never talk about is drive-train upgrades.
How much does the supercharger run for
modern engines (think LS3, 5.7/6.1 Hemi, Ford whateveritis) are built
tougher than they look compared to engines of past. This motor at this
boost should be fine on the street.
I hate supercharge whines man that sucks
Hmm I know a twin screw plus turbo is possible but could you fit this
procharger and turbo?
its possible to aply a On off “boton” to a supercharger? usim for example
an electric clutch pulley? thanks
You guys skipped anything on reassembling the PCV lines. Does the kit
include PCV breathers or anything? I know you shouldn’t run boost from the
intake into the PCV and crank case lines! 😮
hows this engine doing now? did u blow it up? 😛
That is a good question and i figured id jump in and help. Upgrading the
internals of an engine is a must when it comes to forced induction,
however, when it comes to boost (as you heard him say in the video – aka
PSI), the higher it is the more strain it will put on the engine. Which is
why it is important to upgrade. But with low boost it is not a major issue.
Hi, I live in India, I need to know how to install a Supercharger to Honda
Civic 2008, And which Kit is best suitable?
ls1 f body kits are shit, belts always slip, charger is too small for
future upgrades, plastic junction box for the boost hoses is just piss poor
quality. must admit it did make some good power though.
3:51 That guy need to take a dump quick lolll
what is the best kit for a 350 small block chevelle where the supercharger
stays under the hood? would the one in the video work?