In this video I show you how to get at the electronic throttle body on a F150 or F250 that has a 5.4L 3v engine and the unique service procedures that come along with it. How to reset your…
In this video I show you how to get at the electronic throttle body on a F150 or F250 that has a 5.4L 3v engine and the unique service procedures that come along with it. How to reset your…
You must be logged in to post a comment.
){kind=link}
I really like this video and appreciate the clarity you use with each
component. For some reason I cannot find the PCM relearn video you speak of
and I need to replace my throttle body today. Would you mind linking it to
this response?
Thanks again for your time with these videos
I have an 06 F250 that I bought for a plow truck. When I was putting the
plow harness in, I had to disconnect the battery…This truck would not
idle without dying when you came to a stop …I FINALLY found your vid…I
cleaned the throttle body and then used your video on how to clear the pcm
values….THANKS Bud… A Ford mechanic friend told me it was the fuel pump
module, so now I have an extra one of those….Thanks Again, you really
know what your talking about….
Do i have to do the relearn procedure if i take the throttle body off just
to clean it? Its an 05 f150 5.4 3v by the way. Thanks
i have a 2006 ford expedition with a 2135 2106 2135 2106 code would be the
same as this video
Great video, my set up was slightly different but following the video I was
able to replace my throttle body. I had the p2104 code and 2111 codes. I
replaced the throttle body, codes are gone but the shuddering I get when
excelerating from overdrive to the passing gear is still there. Also, when
clearing the codes by following you other video, if my radio presets
remained after 5 minutes, does this mean the reset did not take effect?
when you say the tp sensors should mirror should they bee the same readings
or different.
Great video. I followed exact steps and it took me 20 minutes to replace.
No engine stuttering or engine fail safe mode anymore. thanks
What is that part called in the lower left of the screen with the green
cap? I have to sometimes disconnect the lower hose on it when I fill up my
gas tank other wise the gas pump will shut off every half gallon or so.
Also, does it control anything else? My AC in the truck goes to defrost
when I give it gas then back to the normal air vent when I let off the
throttle. I have a 2006 F250 5.4l xl 4×4. Thank you
Is that close to the same thing as a code about the IAC circuit condition
or idle speed higher/lower than expected? I got that code from Autozone for
my 2004 F-150.
So whenever these throttle bodys give out, you gotta replace the whole tb?
damn drive by wire…I bet there not cheap
Funny, I just had this 2 weeks ago on a expedition..
Another job well done.
Thanks for another excellent vid. Please do a timing set vid on these
motors if you get one of them in. Thanks again.
Great video. I think you should charge more for filthy motors.
Could the customer have just had the TPS replaced ?
awww yes ye old p2135, Gm has gotten to the point a year or 2 ago where we
see that code just replace the sensor do not diagnoise it:P love it pays
1.2 takes .8 to replace and repropgram the ecm.
but my fuck when that sensors bad she bucks and surges haha kinda fun to
drive if u expect it, or limp mode
.
Oh dude how do you tell the diff between 2V and 3V’s?