http://airtexenginemanagement.com/homepage.html This video demonstrates the proper procedure to replace the ignition switch. “The information presented in th…
Jeep Chrysler Dodge Plymouth Ignition Switch Replacement
0
Like
Save
){kind=link}
Comments
Write a comment
You must be logged in to post a comment.
Thank you very much for sharing your knowledge through this video.
Thank you for the kind words. Best of luck with your drilling expedition!
Mark Hicks Airtex Vehicle Electronics
Thank you for watching! Take Care, Mark Hicks Airtex Vehicle Electronics
Can you install this without the key?
This was awesome! Thank you! My truck was randomly stalling and having
starting issues, couple of dash lights would not come on when it wouldn’t
start and that was my clue that it was the switch. Dangerous condition
stalling out in traffic. Went and purchased the tamper-proof torx set for
about $12 at Advance Auto Parts and in less than an hour the new part was
installed. 🙂
Thank you for the kind words. All our videos are done in their entirety
including shooting, editing, talent, everything by the Airtex Vehicle
Electronics technical services department. Mark Hicks Airtex Vehicle
Electronics
This looks to be the same as the switch on my 1993 Dodge Ram D250. The pin
on the Dodge pulls out and presses in.
Very informative. When I bought my jeep it only had one working
key….which is now lost. Looks like I’m going to do some drilling. (I’m
not paying some hack locksmith to take out something I’m going to throw
away anyway.) Thank you for the rest of the procedure.
It very well could be the same switch. Chysler Corp. has been using it for
many years on a lot of models. Mark Hicks Airtex Vehicle Electronics
great job…. pretty well a step by step… thanks for your time in doing
the video, anyone else that helped you with anything else with the project.
Thank you for the kind words. Happy we could help you out. Mark Hicks Wells
Vehicle Electronics
Not that I know of, you must have the key! Mark Hicks Airtex Vehicle
Electronics
great video 🙂 I’m working with a 1992 caravan and unfortunately there is
no harness its just wires and as I was not the one to remove the wires I
have no idea how they go on the new switch any chance you can help?
Thanks.