http://www.1aauto.com/1A/Mirrors/Dodge/Caravan/1AMRP00026 1A Auto shows you how to repair, install, fix, change or replace a broken, smashed, cracked, or sha…
http://www.1aauto.com/1A/Mirrors/Dodge/Caravan/1AMRP00026 1A Auto shows you how to repair, install, fix, change or replace a broken, smashed, cracked, or sha…
You must be logged in to post a comment.
Just done this as your instructions – dead easy thanks! However, I needed a T30 torx, not a T27. So have both to hand.
Unfortunately we are working on other videos are this time but we consider this one for later on down the road.
Can you post a how to for replacing the mirror glass on a 07 dodge durango? Mine is cracked in the middle and i have the part just not sure how to install it. Most seem to clip on but i don’t want to screw it up.
thanks really helps the centre were my mirror folds fell apart 2006 caravan
thanks really helps the centre were my mirror folds fell apart
thank you, very easy.. did this in less then 10 minutes thx again
Thanks- didn’t know how to go under dash until you mentioned it, and about using the old gasket.
On my new on the top plastic clip that holds the interior plastic frame to the exterior plastic body broke, so I fashioned a large paper clip that would follow the contours of the parts, put that under the bolt on the window side, and that held the pieces together up top.
great video brought parts from these guys and will do it again great products and prices
The basics should be fairly similar.
nice job! thanks for the info mine is a 1998 you think its much different? looks simlar
In case you lost a fight with a garage pole. Darn garage pool >:^/ whole mirror fell off
I got a Chrysler T&C Limited 2003, and would like to upgrade the front bumper to 2005 with the headlights and grilles, does anybody knows if it works? or there are some complication issues if i try to do that? it fix? ‘cuz the replacement it seems similar.
I will appreciate any help.
awesome thanks
Only extra thing to but was the T-27 screwdriver at $7.00 from Sears. Completed the replacement in 30 minutes. Would agree on replacing the gasket with the original. Great video.
Just finished this install, thanks for the great video. Made it into a 30 minutes project. FYI- the gasket that comes with the 1aauto part is way to thick to properly fit. I used the factory part off the old mirror instead. Fit was then great….Also, to access the plug, you have to remove the roof frame inside panel (two clips in upper third of panel), then the front most dash cover lifts out easily. Replacement was simple. Power/heated mirror worked fine for power only van.
Thanks for adding Jim!
great video…..just a note for anyone with a power/heated mirror. The power plug is next to the dashboard mounted speaker. You’ll have to slightly lift up the dashboard cover to access the plug. First remove the plastic side pillar cover and then the dashboard cover. Don’t use too much force when pulling on the plastic parts….go easy on them.