my chrysler 300m was not starting just making grinding noise … well took it off sure enough it was just the starter that went bad , bfore u take it off mak…
1999 chrysler starter replacement install and removal
23
Like
Save
){kind=link}
Comments
Write a comment
You must be logged in to post a comment.
looks like a used starter, the yellow marker
Cuervo’s for all!
Hey thanks man, this is just what I needed! I was wondering if you found a better way to actually remove the starter than I did, though. Cause for me, I literally pulled on that thing for three hours and it finally came out of the casing around it. The underbelly of that car is a fucking nightmare; there’s no room to work with anything at all.
did you have to remove a underbody splash sheild and a intermediate steering shaft bolt.(i cant find the intermediate steering shaft ) I already remove the three bolts and unscrew 1 bolt i beleive from the connection but i cant pull it out cause i cant get to the last connection of the starter?
@kaliyah lea I used the same too to remove the bolts I’m not sure what size was it and the connector I just used a flat screw driver it’s hard to remove cuz it’s kinda stuck in thir but inky install I had to break the clip as I show in the video
WHAT TYPE OF TOOL DO YOU USE FOR THE LAST BOLT THAT IS VERY HARD TO GET CAN YOU PLEASE TELL ME THE NAME OF IT AND THE SIZE.
hey you shuld watch this vid on torolocoUNO channel