TV Host and Custom Car Builder David Welch gives us a little bit of knowledge about the features, benefits and installation tricks for easily dropping your classic Chevrolet or GMC Truck with lowered coil springs. After the quick install, Dave also gives you a few things to watch out for when doing your own drop spring conversion. More at www.brotherstrucks.com
67 c20 do you have kit
Thanks for all the videos. Makes things alot easier knowing what I'm getting myself into before hand. Just a tip from the original service manual- there is a notch on the spring retainer cups that line up with the end of the coil. Book shows end of coil on bottom to inside and end of coil on top to the outside. I just lined mine up where it was the least binding.
Are you replacing one spring at a time? To not cause the whole axle to shift around? I’m about to replace my rear springs, shocks, and track bar.
What wrench and sockets sizes were used?
Is there any way to lower the rear of a 1966 GMC 3/4 ton leaf spring truck 2 inches? Can't find any parts anywhere! Please help!
Ok, I got my lowering put on. 5in in the back. I am waiting on my shocks . When they come in I will put them and the hard pan bar on. After setting it on the ground the passenger side is 1in lower why.
So it took forever to get my springs, still waiting on my shocks. My question is I started to install my new springs and the bottom caps are way to small.Top will work. Do I need a different set of caps and if so can I have part # and cost.
David, Thank you for the detailed video. I am doing front and back drop 3 / 5 springs and shocks this weekend. wish me luck.
Thank you for making this guidance videos. Thanks to yoy guys we are able to save alot of money on labor, therefore we get to buy more parts from you guys ha
I have a 1970 c10 What’s the best way and what do i need to drop it 6 inches in the rear?
Is their a video that shows fitting the pan hard bar and adjustment of it
I have a Chevy c10 truck and I don't know the year model and I want to fit it with air ride suspensions.where can I check to see the year model maybe? Thanks
I'm working on a 63' c-10 longbed I have air bags in the front and back.in the rear I also installed a small c-notch.im looking for a littlle more drop,can I add a 1" lowering blocks to give me that little extra drop?
How low can a person go concerning pinion angle?!
Does Brothers sell the non-adjustable tracking bar?