i installed a new powersteering rack, and then naturally my alignment was
off, so i got it professionally aligned… after the alignment, the
steering was off… however, the alignment is perfect! it drives perfectly
straight, its just the steering wheel is off to the right. So i am going to
“reseat” it i guess? so i guess i’ll move 20 degress off the marks i will
make
position of the steering wheel so that it gets put back on the same way it
came off. i also marked the position of the steering wheel position sensor
lol.
If I am putting an aftermarket grant steering wheel on with a short hub
will the turning signals still work
i installed a new powersteering rack, and then naturally my alignment was
off, so i got it professionally aligned… after the alignment, the
steering was off… however, the alignment is perfect! it drives perfectly
straight, its just the steering wheel is off to the right. So i am going to
“reseat” it i guess? so i guess i’ll move 20 degress off the marks i will
make
What were those marks you made? I have to adjust my Steering Wheel 15-20
degrees to the left…
Pretty sure it was a T55 torx bit. There’s no way I can check right now, I
moved back to school.
good videao – thanks..
position of the steering wheel so that it gets put back on the same way it
came off. i also marked the position of the steering wheel position sensor
lol.
thanks and you’re welcome
I was marking it’s alignment so when I put it back on it isnt crooked. Why
do you have to adjust your steering wheel?
What size socket is that to remove wheel?
they should….they’re not connected to the steering wheel
that should do it
Also what were you marking with the green and blue
T55