In this video I strip apart the front end of my RS6 to tackle a DIY replacement of my PCV unit and find other expensive surprises along the way.
In this video I strip apart the front end of my RS6 to tackle a DIY replacement of my PCV unit and find other expensive surprises along the way.
Comments are disabled for this post.
Subbed. Had the oil separator and PCV done under warranty a week after getting my C7 (when Audi finally made the problem official)
Also loving the garage. I’ve just had my garage extended so I could fit the RS6 in, with pretty much the same roller door. Just need to do the flooring and get some decent lighting so I can get some paint correction done.
Keep up the great content!
Great work! Clear instructions, well explained and great footage. Too often you find instructional videos missing vital steps! I note there are two deep torx screws either side of the bumper that is not easy to reach. Would have been great if you showed what you used to get to them.
Went for a test drive in one of these ,the other day.Got back to the garage and coolant was pouring out from the same place must be a common fault ?
Loving your work!
Bumper is just bumper if you’re American, not front fender lol