This video shows you how to cut side marker lights mounting holes onto your Acura RSX. The entire cutting time required is approximately 25 minutes per fende…
This video shows you how to cut side marker lights mounting holes onto your Acura RSX. The entire cutting time required is approximately 25 minutes per fende…
You must be logged in to post a comment.
@jdm12345100 if you take your time and be careful, not likely. Use brush
primer and touch up paint to seal the cut after you’re done.
how much does it cost to have these lights installed if you already own
the? someone please reply
@Scorpion85629 None in the video since i’m limited to 10 mins only. But
yeah, it was filed down, primered and touchup paint was applied.
Your technique is is pretty good. Thanks for the vid. Now I won’t buy a
fender
can this crack your paint? nice video
@skhou o yea hum maybe i should put side markers on mine too
Can’t you use a smaller disc to cut the little sides to make it easier?
Not at all. It was a lot easier than I thought when the right cut-off disc
is used.
What, no file set?
@dstk1423 usually around $50.00, more or less.
@GEOdozer420 yes this can cause rust, after you cut the whole out, you
should apply primer with a small brush around the inside area that is left
cutt. Also i recommend using a smaller blade like 1 inch blade and cutting
from the middle like the diagram states.
cant this cause rusting?
finally a vid =D thanks for makin this vid
Do u need a air compresor for this?
Why would you purposely cut a hole in your fender to install a side marker?
oh yeah definatly its not worth it you are lowing the resale value of your
car by cutting thoughs holes
safety first… if it weren’t for visibility’s sake, i would never consider
cutting holes in my ride
would this work on a integra?
Where did u get the template bro i need one for a da integra!
nice but arent u afraid of messin up when u did this?
HEY
@brigan10 The cutting part, yes. The template, no. You’ll need to use the
specs for Integras and correct side marker lights.