In this video I will show you step by step how to change / replace Rack and pinion in this 2003 Acura MDX.
Be sure to follow me on my social media accounts!
facebook: https://www.facebook.com/a2zautomasters
instagram: https://www.instagram.com/a2zautomasters
How much liquid does it have?
Is the Honda and Acura the same, whichever of the two works?
Can I do this at home I obviously don't have a lift rack but I have a sinking suspension the rack and pinion needs replacing on my 05 mdx is it possible to do at my home with a jack and jack stands ?
Subscribed simply by the fact he read the comments of people who were stuck and actively tried to help them figure out their issues
Great video thank you
What size are the bolts in 7.50
How much fluid after change? I'll be doing this job on a 08 this Saturday
ايه الحلاوة دي. شغل ممتاز و معلومات قيمة. ربنا يباركك
We are in Hobart,Tasmania.
Our car mdx (Honda) 2003 had an issue with the steering rack, the mechanic said, this is an expensive job and prety hard to found the part.
So he suggest me to not worried about that.
Fine for one month one day
Having a miserable time accessing the 2 lines at the rack from either top of engine bay or from underneath. Going to try your method of disconnecting the one at the other end once I find it, and then dealing with the other line once the rack is pulled out a bit. Thanks.
Is the P/S pressure sensor fixed as part of the P/S pressure hose? If I am replacing the P/S pressure hose, do I need to replace the sensor?
How much would a job like this cost on this exact vehicle?
Great video was wondering if you have any tips to remove stuck subframe bolt? It came loose a little bit but got stuck after that
Great video. Very straightforward and helpful! Thank you!
Thanks so much for this great video needed to remove front and rear engine mount. Do you need to do alignment after dropping the subframe? Thanks!
Do you have to support the engine cradle from coming down? My colleague says the engine and transmission is attached to the cradle and all will fall down if it's not supported.
Nice video, thanks very much for taking the time to make it! I've had the rack out of my '06 MDX before, but it's been about 4 years, and was looking for a good video to refresh my memory. This video did the trick, and you even showed me a few good tips that will make it go even more smoothly this time. Cheers!
EXCELENTE VIDEO
Great video!
Ecxellent work the vidio has been very useful.
The two bolts 17 mm that hold rackand pinion to subframe do not aline, actualy only the upper one doesn't. I tried it for more than an hour.
Didn’t tel Us what was wrong with the one replaced, leaking or damaged?
Great Tutorial thank you!
What about the engine mount by the steering pump? If that isn't loosed, would it allow the frame to lower?