AC Clutch Fix 05 Volvo S40I How to Repair Without Pulling Compressor Easy Fix by Removing Shims DIY

AC Clutch Fix 05 Volvo S40I How to Repair Without Pulling Compressor Easy Fix by Removing Shims DIY

in our video titled “AC Clutch Fix 05 Volvo S40I How to Repair Without Pulling Compressor Easy Fix by Removing Shims DIY”
We show you On Our 2005 Volvo S40I We were having an issue with the AC Clutch disengaging after the clutch heats up or once the engine speeds up past 1200 RPM. From factory these clutches are set with a low tolerance. So after these run for a while the Clutch material wears down and this causes excess air gap which causes the clutch the slip and disengage. So Behind the Clutch face and the pulley these comes with a set of shims to spaced the clutch out for proper tolerance. By removing the Clutch face and removing the thicker shim (of the 2 shims) this closes the gap that is caused by wear over time, And enables the clutch to operate properly. This is a simple fix, That costs near to nothing. if You end up renting the AC Puller kit from Autozone or Oreillys Auto parts, then You will need to have (3) 5mm bolts to screw into the clutch face to pull the pressed portion away from the clutch pulley, to access the Shims. Once the shims are removed simply install the clutch face and tighten the main bolt down snug. We hope this is helpful and fixs your issue with the AC on Your car.
If You find this helpful Please Like this Video
& feel free to Subscribe for our future uploads.
Thank You. =)

AC Clutch puller kit – http://ebay.us/TlU8hV

Follow Us on Facebook & Instagram!
Facebook – https://www.facebook.com/LostVisionsPerformance/
Instagram – https://www.instagram.com/lostvisions_performance/

Rental tool
Autozone AC Clutch Pulley Puller $120 which you get back once you return the rental tool.
(3) 5MM bolts $5.

5,357
Like
Save


Comments

Naomi Trevino says:

Thank you!!!! ❤️❤️❤️

Tom Randolph says:

This is a great video! Did you put a M6 bolt in the center clutch hole before using the 3/8" screw on the a/c clutch tool? Other videos use both 3 M5 bolts and a M6 bolt in the center. Thanks!

Gerhard G says:

Thanks, my Mitsi has the same type of ac pump. It's a pity I only saw this after I took it out of my car as it would have saved me a regas. I dont have access to the puller tool so will build it myself. What size bolt is in the center?

Michael Ro says:

Awesome thank you from Montreal!

Gus Martinez says:

Nice! Do you know if the t5 is the same?

suzan1mal says:

Very helpful! I have a 2006 S60. I know I have a leak in my AC but have not had a problem in years past after I had a recharge. This year, they charged it, but after it was taken off the machine and they had me run the AC, it went warm. They said that the compressor clutch kept going off. I’ll see if my husband is willing to try this fix before we take it to an AC person.

Comments are disabled for this post.