See http://www.myturbodiesel.com/1000q/multi/ignition-switch-lock-cylinder-removal.htm for full details. Volkswagen ignition switch repair and disassembly, a…
Volkswagen ignition switch repair and diasssembly
35
Like
Save
){kind=link}
- Tags:
diasssembly, ignition, repair, Switch, Volkswagen
- Categories: Volkswagen
Comments
Write a comment
You must be logged in to post a comment.
This is the immobiliser lock reader that VAG will swear blind to their paying customers CANNOT be removed lol. They are such bullshitters it’s unreal.
I went to my dealership to ask for the C L I P tool and they laughed at me 🙁
I went to my dealership to ask for the C L I P tool and they laughed at me 🙁
This was well done and helped a lot on my 2000 TDI. a tip I saw on another vid (prior to my starting to take off the wheel) was that the lower trim screws under the wheel can be reached by turning the wheel enough. (no need to remove the wheel, but I suppose this is covered in your trim vid). Unfortunately my latch doesn’t retract after the “VW Special tool” is inserted approx. 1.25″ and bottoms. Pushing in and pulling and turning the key slightly doesn’t free it up.
Thanks, now I know where to glue the rfid pill onto 🙂
Genial!, con este viceo acabo de hacer funcionar nuevamente mi jetta A4, Gracias!
Great!! With this video I just made to run again my jetta A4 , Thanks!
Outstanding video. Subscribed!
Can you post a video on how to remove the whole unit from the steering colum the shaft that goes from the key to the ignition switch on mine is broke thank you
i have a 98 vw jetta gt, when i turn the key to start the car i need to lift up hard on the key to hit the right spot. would you know what part i need to order? or is this part fixable? Thanks
great thx, my daughters car is having issues with the ignition key sticking and now i have an idea on what to do next.
How I remove the switch from the steering wheel?
thanks
cheers mate this helped
Would this work the same (replacing the lock cylinder) on a 2007 Jetta? If so, where would I find the part?
You hire a locksmith to fit a key to it. Replacing the lock wtth a parts store one will result in the need for programming, and make for a mismatched lock set.
Locksmith
City Lock
Boulder Colorado
driilll
Great …. thank you..!
I have lost my key & bought a new key + cylinder how do i remove old cylinder without my key to turn to pos 1 ?