Nice video. but for people watching this, this was a really easy cv joint to remove . some of these can be a bastard to remove and refit. Ive done a number of them as im in the trade. I think the more wear on the clip causes problems and also when non genuine parts are used.. but there still a bad principal by vw and i do like the vw as a hole
Excellent video off to do my golf ,great real world commentary ,and camera work without any assistance , assuming all was ok after , changed them before and they started cracking again after 200 mile always wondered were my mistakes were not correct torque ,tks again
i put the threadded bolt back in and it damaged the bolt so took joint apart only to find case harning was gone on cv joint 😮 but the bolt works but use a small piece of bar before extraction
Great job mate. The bottom arm bolt was a pain in the ass to push down! Had to beat the shit out of the outer part to get it loose. Video quality could be better, got the idea anyway, thanks alot! Cheers from Finland 🙂
Hi, nearly done and I've come stuck, cannot get the lower wishbone in! Anyone else got this, any advice, have turned fully to right on right wheel, it's like the wheel hub needs tilting back to get in?!
Thats not the correct way to do this job
Nice video. but for people watching this, this was a really easy cv joint to remove . some of these can be a bastard to remove and refit. Ive done a number of them as im in the trade. I think the more wear on the clip causes problems and also when non genuine parts are used.. but there still a bad principal by vw and i do like the vw as a hole
Thank a lot
Great video mate i can understand this one as its english…but lay off the weed lol
Thanks for the very informative video, got two done this morning in a very short time after watching this 🙂
Anyone give me any advice on how much it should cost to change the driver side cv joint on a 2005 clio please
Excellent video off to do my golf ,great real world commentary ,and camera work without any assistance , assuming all was ok after , changed them before and they started cracking again after 200 mile always wondered were my mistakes were not correct torque ,tks again
Good video thanks
i put the threadded bolt back in and it damaged the bolt so took joint apart only to find case harning was gone on cv joint 😮 but the bolt works but use a small piece of bar before extraction
Great job mate. The bottom arm bolt was a pain in the ass to push down! Had to beat the shit out of the outer part to get it loose.
Video quality could be better, got the idea anyway, thanks alot! Cheers from Finland 🙂
great vid realy helpful ,,,hope it s the same as my 1.9tdi afn engine
Hi, nearly done and I've come stuck, cannot get the lower wishbone in! Anyone else got this, any advice, have turned fully to right on right wheel, it's like the wheel hub needs tilting back to get in?!