Toyota Turn Signals Not Working – Diagnosis and Repair

Toyota Turn Signals Not Working – Diagnosis and Repair

Toyota Turn Signals Not Working – Diagnosis and Repair. Was it my fault? In this video I show how I diagnose and fix the turn signals not working on a Toyota Sienna. The blinkers and hazard lights stopped working right after I fixed another issues on this Toyota. When Toyota turn signals don’t work, sometimes it can be a bad turn signal flasher , a bad combination switch, a bad hazard switch or sometimes it can be something else. The exact vehicle in this video is a 2006 Toyota Sienna CE.

Other videos on this Toyota:
Toyota Stuck in Park: https://youtu.be/Ox1tS1cND2A
The Mechanic Broke My Car!: https://youtu.be/itS1V6p-7SI

Be sure to subscribe for more tool and car repair videos!
https://www.youtube.com/BigDog50001

https://twitter.com/BigDog50001
https://www.instagram.com/bigdog50001/

Disclosure: This channel earns a small commission using some of these links – at no additional cost to you.

The Big Dog 50001 Automotive Channel Store can be found here: https://www.amazon.com/shop/bigdog50001automotive

Tools and Parts:
Launch Scan Tool: https://amzn.to/2ObRQV4
Fuse Saver: https://amzn.to/37EgDJ9
OTC Test Light: https://amzn.to/36GpiJQ
Crimp/Heat Seal Connectors: https://amzn.to/2GzXexm
ATM-LP Fuses: https://amzn.to/2RB87VU
ATM Fuses: https://amzn.to/37CJ2PL

Want a free Big Dog50001 sticker? Send an email to bigdog50001@gmail.com requesting a sticker. Sorry, no international addresses or automotive questions.

Have something you would like to send to Big Dog50001?
Send it here:
Big Dog50001 Automotive Channel
P.O. Box 726
Cortaro, AZ 85652

2020 Epidemic Entertainment. All rights reserved.

Disclaimer:
Due to factors beyond the control of the Big Dog50001 Automotive Channel, it cannot guarantee against unauthorized modifications of this information, or improper use of this information. The Big Dog50001 Automotive Channel assumes no liability for property damage or injury incurred as a result of any of the information contained in this video.

The Big Dog50001 Automotive Channel recommends safe practices when working with power tools, in on or around automobiles or other vehicles, automotive lifts, lifting tools, jack stands, electrical equipment, automotive modules and systems, blunt instruments, chemicals, lubricants, or any other tools or equipment seen or implied in this video. Due to factors beyond the control of the Big Dog50001 Automotive Channel, no information contained in this video shall create any express or implied warranty or guarantee of any particular result. Any injury, damage or loss that may result from improper use of these tools, equipment, or the information contained in this video is the sole responsibility of the user and not the Big Dog50001 Automotive Channel.

41,364
Like
Save


Comments

Big Dog50001 Automotive says:

Tools and Parts
Disclosure: This channel earns a small commission using some of these links – at no additional cost to you.

Launch Scan Tool: https://amzn.to/2ObRQV4

Fuse Saver: https://amzn.to/37EgDJ9

OTC Test Light: https://amzn.to/36GpiJQ

Crimp/Heat Seal Connectors: https://amzn.to/2GzXexm

ATM-LP Fuses: https://amzn.to/2RB87VU

ATM Fuses: https://amzn.to/37CJ2PL

The Big Dog 50001 Automotive Channel Store can be found here: https://www.amazon.com/shop/bigdog50001automotive

DTmoto says:

Hi I recently ran into a problem on my 2002 Toyota celica I went to turn on my turn signals and got nothing no lights on the dash blinking or signals working. My hazard lights will turn on and work no problem I tried swapping the fuse and the relay for it and still no fix do you have any other ideas as to what it could be? Thank you

Jiannis Tsiagkas says:

Hi ,thank you for the video and your knoledge.
Is the same diagramm for the Toyota Hi-Lux 2009 ? If is possible can you send the wiring diagramm ?

wilzon Saeed says:

This is a mechanic I would like to take my car to.

M. CRUZ says:

Good that you checked the other side as well. Thanks for the vid. Awesome!

TALON says:

I need help, my hazards work fine and my right turn signal works fine, but my left turn signal blinks once and stops any troubleshooting advice?

gothebroncos says:

hey man just want to say thanks for the detailed video. I was resigned to getting a sparky to have a look at my issue which happened to be the same as yours, however you inspired me to have a crack at it and I was able to diagnose – well done mate thanks

Dave Smith says:

I've got an 06 Toyota 4 runner with the left rear turn signal out. The front left is working. I switched the socket and bulb from left to right side and the left works on the right side. Any suggestions to help. I've been trying to figure this out for one year with not luck. Thanks, Dave

Nadarajah Sivalingam says:

I am watching your clear videos and at the same time learning lot. I appreciate your services rendered to our society. I am pray for you and your family for good health and wealth. Thanks.

NAIBAF says:

My car has the same thing now I need to find the wire that's grounding. My battery drains every time I turn it off. You think that's the cause of it?
Same problem with the fuse blowing only on one side. Thanks

Ryan Lockett says:

This helped me out a lot

Thank you very much

H Alganis says:

I'm watching this video to learn how to get a constant power while the turn signal is on to power up my after-market side mirror camera for my 2007 Sienna. I wish I can get my hands on a diagram. I'm still not sure where exactly to tap.

Daniel Greenbaum says:

Great video just come across this also so many mechanics out there luv them butt connecters but seen them cause so much trouble on car wiring

relicsun says:

Skillful mechanic, genius, again fine work.

Gaudencio Lactao says:

Sir how about the hassard, even turn off still blinking. And when turn on the car hassard hassard blinking.. Thanks

Ayub Khan says:

Hi is anyone can help me my Toyota Prius
Hazard light keep flushing when I turn left after switch off I have changed the switch in the steering but still the same

Michael Goddard says:

Have an issue similar but different. I turn the left turn signal it goes for a click or two the. Goes off, I do the right it works fine. No fuses blow, hazards work as well, but not directly after using left turn signal. Not sure what to trouble shoot… any thoughts ? Thanks

Joseph Salio-an says:

what might be the problem if the turn signals not working but the hazard works

Shirhad Meah says:

I feel I am learning more about circuit from your repair video than what I learned from electrical engineering class. Thanks

Comments are disabled for this post.