http://www.1aauto.com 1A Auto shows you how to remove or replace the interior door panel trim on your vehicle. You need to remove the door panel for a number…
http://www.1aauto.com 1A Auto shows you how to remove or replace the interior door panel trim on your vehicle. You need to remove the door panel for a number…
You must be logged in to post a comment.
){kind=link}
Thanks! Exactly what I needed and very clear instructions! Needed to get
to the linkage that slipped off my handle. Now I can open my door with the
outside handle… IMAGINE THAT!
I have absolutely no mechanical aptitude. I was able to follow your video
and replace the door handle in my old camry. Thank you so much!
We currently do not have an auto repair video that shows this particular
repair on your vehicle. If you take the door panel off, there should be a
rod or two that connects to the handle and possibly a couple of small
plastic clips that secure the rods to the handle. We do carry the 97-01
Toyota Camry passenger side outer door handle on our website 1aauto.com
part# 1ADHE00013 or you can call Tony @ 866-403-3393
Thanks! That helped me get mine apart w/o damaging any of the fasteners!
All done w/o major problems. 🙂
@tcuk You’re welcome.
havin a hard time gettin the rear interior panel loose to fix the power
window controller….any thoughts?
thanks for the video. made job much easier and i didn’t throw one tool. how
on earth do you get the screw cap back on the big screw underneath the
tweeter? i’ve tried pushing them straight on. i’ve tried starting from one
side. my thumbs can’t take anymore.
@perry244 Yes you would more than likely need to remove the door panel to
remove the speakers.
Mike! This is exactly what I needed. I had a loose passenger side handle –
one of the bolts had come loose. I pulled the door panel, found the bolt
sitting down below and repaired the handle. Thanks very much, and I will be
coming back for more camry advice soon.
@samisim0 You may want to look for any hidden screws that may be holding it
on.
If I purchase this headlight from 1A Auto, will it come with the black
mounting assembly piece referred to at 4:18 of the video? thanks!
@ebarshin Glad to help!
HI DJ, If you remove the door panel, you should be able to reach in and
push the window up into place. You may need to support it to hold it in
place if the window regulator is broke. Hope this helps you out. 1aauto.com
888-844-3393 FREE SHIPPING on all orders in the lower 48 states!!!
@TheViolentj No Problem check out our site 1A Auto dot com. Athough if you
use A1 you’ll find us too!
@me373 For that particular year we don’t.
@kumquatsta We have a outer door handle removal video for the 92-96 Toyota
Camry. It may be a similar process on the 97-01.
Thanks for the tutorial…..i needed to change the door handle…
i have a 1997 toyota avalon my window is stuck midway on the drivers side,
and i would like to make it come all the way up untill i can afford to
replace whatever is messed up. How do i do this? @1aauto
Is this the same for a 1996 toyota Camry?
Though the camera is stationary without zooming in, the instruction is
clear and useful. I fixed mt car using this guide. Many thanks. AtlanLeone1
This video saved me at least $60 today after a greedy, arrogant mechanic
tried to rob me like a blind fool. Thanks for the video, please keep up the
good work!
Our headlight are made exactly like the ones that came from the factory.
thanks for this video…I have a 2000 camry and need to replace a broken
drivers exterior door handle…do you have a video showing how to do that?
thanks again for your time doing these videos.
@tcuk The basic removal of the panel should be pretty similar to your
vehicle. If you take your time and remove any hardware off of the door
panel you should be able to remove it in a similar fashion.
@1aauto Thanks…much appreciated.
How do I replace or fix the outside passenger door handle because i can
only open it from the inside and my security system is messed up is there a
way to fix it or cut the alarm wire?
Thanks, I went to Pull-a-part and they didn’t charge me for it cause it was
so small. 🙂 thanks for the video! My car is now back together.
thanks for the detailed video instruction. i was able to do it myself easy.
What if I cant roll the window down?
i’m assuming after removing the door panel, removal and replacement of the
exterior door handle is straightforward? will there be a video for that
soon?
@bigmohawkguy There’s not really a specific name for that tab. You could
probably get one from the junk yard or your local dealer. Hope this helps
you out.
@KierkegaardSayWhaaa Rolling the window down makes it easier but you can
still get the panel off with the window up. The step of lifting the panel
up and off is more challenging as the panel is being ‘held” by the window.
Put a piece of scotch tape on the side of those covers and they will not
get lost.
Would this be similar to a 98 Corolla? I have the change the assembly/motor
on mine.
do i have to do this in my chevy lumina because i pop off that screan and
theres no bolts for the speaker or enough room for it to come off
THANK YOU for posting these videos! I have absolutely no experience with
fixing anything automotive, and I was able to successfully replace my
window regulator/motor assembly in my 1999 Camry. You saved me so much
money! Thank you!
Thank you for checking us out. Have a great day. 1aauto.com 888-844-3393