In this video we show you how to install a rear shock absorber on a 1993 Toyota pickup 2wd v6. We replace the factory shock absorber with a new heavy duty sh…
In this video we show you how to install a rear shock absorber on a 1993 Toyota pickup 2wd v6. We replace the factory shock absorber with a new heavy duty sh…
You must be logged in to post a comment.
){kind=link}
im gonna put ranchos on mine …..nice vid
Any chance you have the truck and can give me the axle code on the vin tag? I’m curious what ratio the V6 2wd’s had.
lmao on the FF part haha!
no, this will not raise the height of the rear end
oh have fun with that if its a first gen frontier because its going to be a bitch to take off and put on the shock on ur truck
Thanks for video, bout to change minez on a Nissan Frontier…
Yeah, the truck does drive like new again. I just bought another set for my G35 🙂
To anybody wondering my Toyota service manual says the bolt torque should be 19 ft-lbs for the 2wd model and 53 ft-lbs for the 4 wheel drive. Same torque for the top and bottom mounting bolts.
FYI kroil or PB blaster are the two best commercial products for stuck nuts and bolts. Auto trans fluid and mineral spirits works fairly well in a 50/50 mix inside a spray bottle once you prime its pump. Careful around new rubber though just in case.
nice video, I’m about to replace mine with ones exactly like the new ones you just put. how are they? do you feel your truck drives like new again?
i tried to loosen the nuts but they are so rusty and stuck. I’m going to use heat and see what happen
thanks for the video
You can also put silicone spray in electrical connectors. Makes them easier to reconnect and drives out moisture.
I also spray connectors before I dis-connect them.
my xterra has a rear suspension like that and we are gonna but 1 inch drop blocks on it ti make the rear level with the front and now im confident i can take the shocks off for the install and put them back on
nice vid 5*