Wow! I changed 2 today and only removed 1 of the 19 mm bolts( I used 3/4) also removed the 2 starter bolts. that's it other than disconnecting the battery first and taking the wire of after the starter is lose. Not bad at all
Ohh, you donĀ“t have to do all this… * Just let it stand on all wheels. * Take off the carb (Two bolts + snorkel). * Remove the large bolt (19mm near the engine). * Remove the two long bolts holding the starter. * Now, all you have to do is lift the engine a little bit, to take the starter away…
Hey … Did you end up having any problems with the aftermarket starter after some use I don't wanna go through all that and put a starter in that's going to last a week…
Wow! I changed 2 today and only removed 1 of the 19 mm bolts( I used 3/4) also removed the 2 starter bolts. that's it other than disconnecting the battery first and taking the wire of after the starter is lose. Not bad at all
Ohh, you donĀ“t have to do all this…
* Just let it stand on all wheels.
* Take off the carb (Two bolts + snorkel).
* Remove the large bolt (19mm near the engine).
* Remove the two long bolts holding the starter.
* Now, all you have to do is lift the engine a little bit, to take the starter away…
Hey … Did you end up having any problems with the aftermarket starter after some use I don't wanna go through all that and put a starter in that's going to last a week…
Great vid man! This was a life saver I spent hours trying to figure it out then I found this video