BEST Subaru clutch How-to Replacement Part 2 Getting the Trans off the engine. briansmobile1
S-wrenches → https://amzn.to/2Ertl1D → The “Ibis” → https://amzn.to/2U2o324
Facebook → briansmobile1
Instagram → briansmobile1
Twitter → briansmobile1
Wanna chance to see your hat, shirt, sticker etc in a video?
Send it to:
briansmobile1 P.O. Box 282
Cedar Valley, UT 84013
Pull-a-Part Challenge video 3 → https://www.youtube.com/watch?v=Fu4V9I8i6mU&t=136s
Thanks for watching my videos. I hope they’ve helped you tackle something you thought was a challenge and left you feeling like a FORCE for win! And if nothing else, perhaps you had a laugh and were entertained!
Disclaimer:
Training and discretion is recommended before attempting anything portrayed in this video.
Due to factors beyond the control of briansmobile1, briansmobile1 assumes no liability for injury or property damage incurred as a result of the presentation of this information contained in this here video or any of the other briansmobile1 videos.
briansmobile1 recommends safe practices including the use of personal protective equipment such as eye protection, hearing protection, gloves, guards, shields, and reputable gear when paramotoring.
I am an Amazon affiliate, Prime member, and general Amazon nut. I provide links to help you find the right stuff for the job quickly, confidently, and conveniently.
This is the exact video I was looking for! Finally someone with an easy and well explained clutch swap thanks so much
What state you located?
This is money. I did one and this is a great guide that I wish I had.
Did you have to loosen up the 2 bolts on the clamp in the center of the turbo to finally get the transmission apart?
Hi mr brian. Subaru sti replaceing clutch assembly should be remove fork clutch shaft?
You didn’t turn the flywheel?
Yeah I'm pulling the engine for sure. Seems much easier. Only done it once before but I feel confident. Thanks for the info Brian
Thanks for the videos! Watched over a few times to pick up the tips and carried out my own clutch/flywheel change recently with out too many issues. Mainly separation of the block and realignment of gear box back on after… several tries later and remembered to use the driveshaft to rotate the gearbox slightly, went straight on after that!
Yes I'm happy, I've done plenty of clutches in my life, but no way I'm doing my Subbie after watching this
Great videos!! Again great and very inspirational informative videos. The only thing I would add is to emphasize breaking the seal on the bell housing of the motor to transmission. As I had to pry mines apart, both dowel pins stuck to the transmission. Don’t be afraid to use a wedge to separate. Good stuff Brain and thank you……
Hey thanks for the videos they were extremely helpful doing and tackling my flywheel and clutch in my 2012 WRX now I have a question my front driver side axle seal is now leaking I watched four different videos just pop the axle seal out with the tool that I have or do I actually have to spin that piece out and yelled that controls the backlash and put it in from the back side because the videos I watched show is all being done a different ways and I would trust your advice over there thank you
Nice vid. I changed my clutch 1 month ago, now I broke my transmission with the new clutch kit.
I have already removed the gearbox, but the throw out bearing just sits on the clutch now. How can I remove it to put it on the transmission? Or can i put the transmission on it like that, and then put the fork on the throw out bearing from the top? Would be thankfull for every information.
Exhaust ends you talking about the y pipe or the x pipe on a dual exhaust vehicle?
Re installing transmission can be a pain also
Moving transmission and engine is hardest part of a clutch I agree
Lol love the clutch guide bundle ring
Great walk through brian like always brother
Yup, yank the engine forward. Seems like you got a new jacket Brian, that thing sounds crunchy when you move your arms. lol
There must be lots of Subaru's in Utah. Here in California I've only worked on two of them before. Even though the Subaru dealership is right on the other side of the freeway, I don't see very many of them.
If I may ask what brand of clutch kit looks oem.
Thanks Brian. Yep, Its easy enough, I'll pull the H4's right out to work on anything. Good video.
Were you visiting us in Canada recently??? Just wondering about the hat with Canada in bold black.
Brian did Knipex contact you? Joe.
I can change a Clutch with my eyes closed. Because I know You. Because if I did the repair it becomes a Flowerpot.
As the Marine said in the movie "men in black" the best, of the best,of the best…SIR!
Thanks B
In thousands of years they will dig up your clutch string and wonder what kind of cultist ritual it was used for.