Picture Slide show with some tips and tricks on removing ball joints on 95 oldsmobile cutlass supreme and some other GM with that revit/bolt on ball joints.
oldsmobile cutlass supreme Ball Joint Replacement
1
Like
Save
){kind=link}
- Tags:
Ball, Cutlass, joint, Oldsmobile, Replacement, Supreme
- Categories: Oldsmobile
Comments
Write a comment
You must be logged in to post a comment.
thanks !!
I know I did it the hard way then figured to stop being lazy ansd just remove it just be carefull not push to much you can pop the half shaft out and place a jack unerneath it after you have your ball joints in and jack it up a little to relieve some tension.
fuckin A+, I was trying to figure out if I would need to remove the wheel bearings/cv boots… never thought of loostening the swaybar where you showed, I always figured I’d have to just leave the end links or possibly break them thanks alot 🙂 Ive got a 96 grand am 3.1sfi same shit down to the swaybars.