Buy Now!
New CV Axle Shaft from 1AAuto.com https://www.1aauto.com/*/i/1AACV00166?utm_source=YouTube&utm_medium=description&utm_campaign=videodesc&utm_term=9TQqsycArFY
1A Auto shows you how to repair, install, fix, change or replace broken, worn, or vibrating CV axles. This video is applicable to the 08, 09, 10, 11, 12, 13 Nissan Rogue
🔧 List of tools used:
• Flat Blade Screwdriver http://1aau.to/tMj/1AXAA00013
• Pry Bar http://1aau.to/t6/1AXAA00020
• 13mm Socket http://1aau.to/tpt/1AXAA00015
• 18mm Socket http://1aau.to/td5/1AXAA00043
• 21mm Socket http://1aau.to/td5/1AXAA00043
• 32mm Socket http://1aau.to/th/1AAST00003
• Dead Blow Hammer http://1aau.to/taL/1AXAA00091
• Side Cutters
• 1/2 Inch Breaker Bar http://1aau.to/tax/1AXAA00078
• Ratchet http://1aau.to/tkN/1AXAA00016
• Socket Extensions http://1aau.to/tpt/1AXAA00015
• Swivel
• Torque Wrench http://1aau.to/tcz/1AXAA00044
• Bungee Cord
• Center Punch http://1aau.to/tD/1AXAA00055
• Floor Jack http://1aau.to/tck/1AXAA00068
• Hammer http://1aau.to/taL/1AXAA00091
• Jack Stands http://1aau.to/tcp/1AXAA00065
For More Info visit us at http://1aau.to/h/Gf/
⚠ DISCLAIMER:
While 1A Auto strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. 1A Auto is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.
My axle fell out after removing the two 13mm bolts. I guess I was lucky.
Anyone purchased A1 axels? Last time i bought brake & rotors from them the pads is junk.
So, there is no rubber seal on the end, just the dust cap. So if I'm getting drops of fluid on my garage floor… what did I miss?? My installation went just like this. The bearing was seated correctly and flush.
Very very good thanks mi friend
Please tell me that tool @11:42 can be rented some where, same problem with my 2012
What size cotter pin should i use for a 2013 nissan rogue?