http://www.1aauto.com/1A/BlowerMotorResistor/Nissan/Sentra/1AHBR00022 1A Auto shows you how to repair, install, fix, change or replace a bad or broken blower…
http://www.1aauto.com/1A/BlowerMotorResistor/Nissan/Sentra/1AHBR00022 1A Auto shows you how to repair, install, fix, change or replace a bad or broken blower…
You must be logged in to post a comment.
just changed resistor on my nissan sentra 2005 se, using this video as a guide, few things i want to add for my model:
i) there is a bottom cabin panel to remove before you can see and reach the resistor which is at FURTHEST BOTTOM LEFT CORNER
ii) the back screw holding the resistor in place was so tight i had to use WD-40 first, make sure you have a SHORT SCREWDRIVER as the video says there is very little room to work down there
iii) i needed PLIERS to squeeze the connector out of resistor
Thanks for checking us out. Have a great day 1aauto.com 888-844-3393
I stumbled onto this while I was looking for a video to replace the outer door handle on my Sentra. Just so happens, I needed to replace this as well. I saw that it was cheaper so I ordered it through here, and thanks to this video I was able to replace it myself (and my door handle!). I saved money on the part and installation, so I am very pleased! Thanks for the helpful videos and great parts prices! *Note: My car is an SER Spec V, the board on the part looked different, but still worked*
Thanks for checking us out. Have a great day! 1aauto.com 888-844-3393
Great video and reasonable price for the part! You probably saved me $125 by avoiding the dealer price and labor charges. Great to shop at a place that understands customer service. I’ll definitely be back for more parts.
Great video, thank you guys.
The tabs lock it in place. You would need to unlock them to remove the wire harness.
Once again great video! Thumbs up! I just liked and commented on your video so please return the favor and like and comment on my new video, “Indoor Outdoor Species”.
For most of the wire harness clips, do you usually have to push in on the little tab before you disconnect it? I have a bad heat/AC blower and the clip is stubborn and I don’t want to break it.