2008 2009 2010 2011 2012 2013 Nissan Rogue
2013 Nissan Rogue. Visual instructions/directions on replacing the passenger side axle. The boot was only busted open and spitting out grease. Owner just wanted to replace it with a new aftermarket axle.
Labor hours on axle: 2.2 hours
The information contained in this video is for general guidance, not responsible for any errors or injuries that you have done. Samsung W200 pocket camcorder was used to do this video.
Please subscribe and thank you for watching. Follow me on TWITTER: @88bmyvegas and http://lasvegasautoinsider.blogspot.com/
Great video, I really appreciate it. Question, are both front sides similar to do?
Where do you get those markers . been looking for ever for those. Always forget to ask when im in the auto parts store.
The fluid coming out of there sure looked red and not greenish . I would if the owner mixed it with the red stuff .
What is the proper name for the bearing that holds the axles midway to the first joint on the axle . I think mine went out on my Altima after hitting a huge pothole . I hear a growling noise above 35 mph. and higher.
what is the piece you pull off that looks like a C at 4:15. I need a new one and i don't know the name.
excellent video!
I had to remove the bracket because the bearing was stuck. I had to remove the 3 bolts holding the exhaust flex pipe from the manifold to make room for the bracket. it was REALLY tight, but I wiggled the axle and bracket out without completely removing the exhaust pipe.
Great video. thanks for sharing your work. I have a question… My boot have a little leak, is absoluty necessary to change the whole axle? if I change only the boot and add some grease will be fine?…
LIKE HOW HE CALMLY OUTS THE OIL PAN IN. LOL
Did you have any trouble with the ABS sensor? Most of what I've read, people destroy the sensor taking it out, looks like you didn't have to take it out. Was this a FWD or AWD rogue? maybe there's a difference? thanks!
I love that IR wrench its a Beast I love my IR tools
Hey, how did you remove the 4 bolts on the back of the front hub assembly?…I find it IMPOSSIBLE to get back there with a 17mm socket…its too little space.
how the hell did you just pull that out?? On mine the part with the carrier bearing will not budge. Tried for hours!!!
like a beast…
bought a slide hammer and did the trick… just being stubborn. Thanks again!
no matter what I do, I cant get the axle to pull out of the trans and slide out of the carrier housing… its completely stuck…any suggestions? thanks
ya man striaght to the point thanks!
well done! doesn't get any better than this… thank you for the video man!