This is the complete step by step guide on how to replace the control arm on Nissan Juke as well as ball joint replacement.
Nissan Juke Control Arm: https://www.1aauto.com/nissan-juke-leaf-front-lower-control-arm-with-ball-joint-pair-diy-solutions/i/1asfk02363?f=1012609&y=2012
Ball Joint Separator: https://www.walmart.com/ip/BALL-JOINT-SEPARATOR-PICKLE-FORK/16616357?wmlspartner=wmtlabs&adid=22222222222000000000&wmlspartner=wmtlabs&wl0=e&wl1=o&wl2=c&wl3=10352200394&wl4=pla-1103028060075&wl12=16616357_0&wl14=pickle%20fork.&veh=sem&msclkid=91e1ef92e0a611bb0a6fb14016047824
Impact Wrench: https://www.amazon.com/CRAFTSMAN-Bater%C3%ADa-iones-litio-20/dp/B07KKH4L8T/ref=sr_1_5?dchild=1&keywords=craftsman+impact+wrench&qid=1590884116&sr=8-5
If you find this video helpful, please like,share and consider subscribing.Thank you for watching!
I have the same car. I tightened the bushings bolts then lowered the car and left it as it is. Will I have damaged the bushings? What should I do?
clear concise and very well described
My ball joint on my juke just busted as I was parking it so thank you for this video! So very helpful.
To make your life easier, before you torque the bolts you can lift the car up from the knuckle using a floor jack until it barely lift the car from the jack stands.
Great video. Why do you have to lower the car first before you tighten the last 2 bolts
If you leave the nut on the ball joint bolt by a few threads, you can hit the bolt without damaging the end of the bolt.
;Did this job recently. For those who might struggle with the lower ball joint: an alternative way is to disconnect the steering ball joint, disconnect the hub's 2 bolts connection to the spring strut, remove front disc and caliper and take the drive shaft out of the hub. Benefits of doing all this? can easily use a drift to remove bottom ball joint and can easily fit the new one; also on refitting you are lining up the 2 bolt holes in the wishbone with it being in the horizontal position – much easier.
Зачем стучать молотком по резьбе? Ты же потом гайку не сможешь накрутить…
One of my right control arm of nissan juke is bent?
Can i know its approximate cost and is it necessary to change both if one is bent
Very useful video. I did replacement on my Nissan Leaf. Thank you.
Great channel. can You let me know what software you use. Stay frosty :3